RIOTEC LS6300 User manual

1
Programming Quick Guide
-LS6300/LS6320
-FS5020S
Installation
Make sure that the scanner has the correct cable to plug in the PC
as below described:
1.
USB cable Connection:
(Please use correct cable for the interface)
Reset Configuration to Defaults
If you are unsure of the scanner configuration or have scanned the
incorrect codes, please scan the “Default” barcode. This will reset the
scanner to its factory defaults.
Default
2.
PS2 cable connection :
Please read above “Default” first, and then set the output mode as
Keyboard.(On the top right corner)
3.
RS232 cable connection :
Please read above “Default” first, and then set the output mode as
RS232.(On the top right corner)
★If change the difference interface cable, after make the barcode
setting “default & output mode”. Need to re-plug the cable from PC to
complete setting.
4.
Auto-sensing setup (For LS6320 only )
For some scanners have auto-sensing function. Press the auto-sensing
function button shown on below
photo. Default is ON.
*Auto-sensing normally is ON. Press
once is OFF, Press once again is ON.
Barcode Configuration Method:
(Flow chart for setup procedure :)
Start
Configuration
Abort
Configuration
End
Configuration
Multi-Interface Functions
LOUDER
SOUND LEVEL
MIDDLE
LOWER
SILENT
LONG
SOUND /LED
CONTROL
MIDDLE
SHORT
DOUBLE CHECK
(ENABLE)
DOUBLE CHECK
DOUBLE CHECK
(DISABLE)
Multi-Interface Functions
OUTPUT MODE
– KEYBOARD
OUTPUT MODE
OUTPUT MODE –
RS232
SINGLE SCAN
READING MODE
SINGLE SCAN
NO TRIGGER
Keyboard Language (For USB / PS2)
Scan the appropriate country code as below to program the
keyboard for your country or language. As a general rule, the
following characters are not supported by the scanner for
countries other than the United States:
@ | $ # { } [ ] = / ‘ \ < > ~
DENMARK
FRENCH
GERMANY
HUNGARY
JAPAN
ITALIAN
NORWEGIAN
PORTUGAL
SPANISH
SWEDISH
SWITZERLAND
USA
VIETNAM

2
Start
Configuration
Abort
Configuration
End
Configuration
Symbologies On/OFF – 1
ENABLE
CODE 128
DISABLE
ENABLE
CODABAR
DISABLE
ENABLE
INTERLEAVE 25
IDISABLE
ENABLE
INDUSTRIAL 25
DISABLE
ENABLE
MATRIX 25
DISABLE
ENABLE
CHINA POSTAGE
DISABLE
Start
Configuration
Abort
Configuration
End
Configuration
Symbologies On/OFF – 2
ENABLE
UPC-A
DISABLE
ENABLE
UPC-E
DISABLE
ENABLE
EAN-13
DISABLE
ENABLE
EAN-8
DISABLE
ENABLE
MSI
DISABLE
ENABLE
PLESSEY
DISABLE
Start
Configuration
Abort
Configuration
End
Configuration
Symbologies On/OFF – 3
ENABLE
CODE 11
DISABLE
ENABLE
T
ELEPEN
DISABLE
ENABLE
CODE 39
DISABLE
ENABLE
CODE 32
ITALIAN PHARMACY
DISABLE
ENABLE
CODE 93
DISABLE

Information in this document is subject to change without notice.
For more information, please visit:
www.riotec.com.tw
R_140820_01