Risco RisControl User manual

RisControl
Quick Installation Guide
Model: RP432KPTZ

2
Introduction
The RisControl can be used in 3 operation modes, as follows:
•Smart Home + Security –For Security, RisControl is connected to a
control panel via the RS-485 bus. For Smart Home operation,
RisControl is connected to RISCO Cloud via Wi-Fi. If there are
additional RisControl units, a Master / Slave configuration should be
defined.
•Smart Home Only–RisControl is connected to the RISCO Cloud via
Wi-Fi (no BUS connection to the RISCO control panel). In addition,
if there are more RisControl units in the installtion, a Master / Slave
configuration should be defined.
•Security Only- RisControl is connected to a control panel via the
RS-485 bus and to the RISCO Cloud via Wi-Fi

3
RisControl Mounting
Smart Home Standalone:
Step 1

4
Step 2
* 5Vdc/2A Power Supply to USB-C (P/N RP432PSR00A)
*

5
Step 3

6
Step 4

7
Installation using Power Supply:
*
* 100-240VAC Adaptor to 14.4VDC/3A (P/N RP432PS00SAA)

8
When Connected to Control Panel:
Step 1

9
Step 2
Wall Installation
OR

10
3 Gang Flush Mounting Box

11
Step 3

12
Step 4

13
Step 5
Wall Installation
OR

14
3 Gang Flush Mounting Box Installation

15
Step 6

16
Step 7

17
Final

18
RisControl Setup
Step 1 –Select Language

19
Step 2 –Set the Bus Address (Virtual DIP Switch)
Note: This step is relevant only if the RisControl is connected to a control panel.
In Smart Home Only operation mode, this screen will not be displayed.

20
Step 3 –Select a Wi-Fi Network
Notes:
•For installations without a control panel, RisControl must be connected to a
local Wi-Fi router.
•For installations with a control panel:
a) If the RisControl unit is intended to operate as a Master Smart Home
Gateway, connect it to the Wi-Fi network.
b) If the unit is intended to operate as a Slave Smart Home Gateway,
this step is optional.