John Thomas OT-70SL User manual

ITEM NO.: OT-70SL
REVISED MAR 02, 2020
Printed in Vietnam
- 1 -
ASSEMBLY INSTRUCTIONS
Description
Item No.
: HAMPTON SOFA TABLE WITH SHELVES
: OT-70SL

ITEM NO.: OT-70SL
REVISED MAR 02, 2020
Printed in Vietnam
- 2 -
BEFORE ASSEMBLY
Thank you for purchasing this quality product. This product has been designed for easy assembly
and constructed for durability. All parts were checked prior to packaging to insure quality. Prior to
beginning assembly, however, make sure all parts and hardware are included and free of obvious
defect. If a part is missing or defective, please contact the store where purchased. If hardware is
missing, or you need help with assembly, please call toll free 888-944-8396.
IMPORTANT NOTE:
-Place all wooden parts on a clean and smooth surface such as a rug or carpet to avoid the
parts from being scratched.
-Remove all wrapping material, including staples & packing straps before you start to
assemble.
-DO NOT tighten all screws and bolts until completely assembled.
-Keep all hardware parts out of reach of children.
WARNING:
Long exposure to rubber or soft plastic may cause a chemical reaction and damage the
finish of your table. Protect the surface of the table with cloth if you are using any product
with rubber feet or base.
ASSEMBLY TOOLS REQUIRED
NOT INCLUDED

ITEM NO.: OT-70SL
REVISED MAR 02, 2020
Printed in Vietnam
- 3 -
PART LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have the following parts:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
A
Top
1
B
Side frame
2
C
Adjustable
Shelf
2
D
Vertical
frame
1
E
Bottom
panel
1
HARDWARE LIST
When unpacking, please be careful not to discard any parts with the packaging. Before continuing,
please make sure you have all of the following hardware:
NO
Description
Qty
Sketch
NO
Description
Qty
Sketch
1
Long Bolt
(M6 x 35mm)
12
2
Flat Washer
(6.5 x 19mm)
12
3
Lock Washer
(6.5 x 11mm)
12
4
Shelf support
bracket
8
5
Allen Key
(M4 x 30mm x 110mm)
1
6
Screw
(M3.5 x 15mm)
8
7
Leveler
4

ITEM NO.: OT-70SL
REVISED MAR 02, 2020
Printed in Vietnam
- 4 -
STEP 1
Attach side frames (B) and vertical frame (D) to the top (A) with bolt (1), and washer (2) and (3) as
shown below. Tighten with Allen key (5).
STEP 2
Attach bottom panel (E) to the unit with bolts (1), and washers (2) and (3) as shown below. Tighten
with Allen key (5).
Attach levelers (7) by screwing them into bottom panel (E), as shown below.

ITEM NO.: OT-70SL
REVISED MAR 02, 2020
Printed in Vietnam
- 5 -
STEP 3
Insert brackets (4) into the unit as shown below. Place shelves (C) on the brackets and attach with
screws (6). Tighten with a screwdriver.
Adjust the levelers to the appropriate height to level the table.