Riverside Furniture Bella Vista User manual

Bella Vista Bedroom
Assembly Instructions Made in China
8 pcs. for 6/6
4 pcs. for 5/0
ASSEMBLY STEPS:
. Install the eight All-Thread Bolts (C) into the threaded metal plates mounted on the Headboard and
Footboard posts.
2. Gently lean the Headboard against the wall where the completed Bed will be located in the room.
3. Position one end of one Bed Rail onto the All-Thread Bolts and fasten with the Spring Washers (A)
and Hex Nuts (B). Only partially tighten the Hex Nuts until the Footboard has been connected.
Repeat for other Bed Rail.
4. Position and connect the Footboard to the other end of the Bed Rails as in previous Step.
5. Carefully align the Footboard to be 'square' with the Headboard. Using the Open Wrench (D)
tighten all Hex Nuts attaching the Side Rails to the Headboard and Footboard.
To prevent undue stress on
any bed, always remove the
mattress and box springs
before moving bed.

Page 2 of 4
2 pcs.
1 pc.

Page 3 of 4
To Remove Drawer:
With the drawer fully open, the drawer slides must be released
by pressing the "trigger" lo ated in the slide either up or down,
depending on whi h slide is being released. With both triggers
pressed, gently pull the drawer until the slides release.
Carefully reinstall the drawers by aligning the hannels of the
drawer slides and gently pushing the drawers ba k into the
abinet ompletely.

Page 4 of 4
Caution:
To prevent undue stress on any bed frame, always remove the mattress and box
springs before moving.