Rockwell Automation Allen-Bradley 194U Series User manual

Installation Instructions
Disconnect Auxiliary Contacts
Trennschalter-Hilfskontakte
Contacts auxiliaires de déconnexion
Contatti ausiliari sezionatore
Contactos auxiliares de seccionador
Вспомогательные контакты разъединителя
绝缘端子辅助接触器
(Cat 194U-NO, 194U-NC, 194U-NONC)
Bulletin 194U
WARNING: To prevent electrical shock, disconnect from power source before installing or servicing. Install in suitable enclosure. Keep free from contaminants.
WARNUNG: Vor Installations- oder Servicearbeiten Stromversorgung unterbrechen, um Unfälle zu vermeiden. Die Geräte müssen in einem passenden Gehäuse eingebau
und gegen Verschmutzung geschützt werden.
AVERTISSEMENT: Avant le montage et la mise en service, couper l'alimentation secteur n d'éviter tout accident. Prévoir une mise en t ou armoire appropriée.
Protéger le produit contre les environnements agressifs.
AVVERTENZA: Per prevenire infortuni, togliere tensione prima dell’installazione o manutenzione. Installare in custodia indonea. Tenere lontano da contaminanti.
ADVERTENCIA: Desconectar la alimentación eléctrica antes de realizar el montaje y la puesta en servicio, con el objeto de evitar accidentes. Instalado en una caja o armari
apropiado. Proteger el producto de los ambientes agresivos.
警告：为了防止触电，在安装或维修之前必须先切断电源，安装在合适的设备箱内，防止接触污染物。
EN 60947-5-1
UL 508
Product of Bulgaria
0
Main contact
Test contact (NO)
Test contact (NC)
1 0
Test 0
Auxiliary contact table
ПРЕДУПРЕЖДЕНИЕ: Во избежание поражения электрическим током, отсоединить от источника питания перед установкой или обслуживанием.
Устанавливать в соответствующем корпусе. Предохранять от загрязнений.
194U-NO
194U-NC
2 x 18 - 14 AWG
2 x 0.75 - 2.5 mm²
POZIDRIVE
M3.5 Form 2
37
21
11
13
mm
0.8 Nm
(7 lb-in)
At the end of its life, this equipment
should be collected separately from
any unsorted municipal waste.
194U-NONC
Screws must be accessible
when installed
54
23 36
8.75
2 x 0.75...2.5 mm²
2 x 18...14AWG
POZIDRIVE
M3.5 Form 2
0.8 Nm
(7 lb-in)

BASE
194U-NONC
DOOR
194U-NONC
4
3
2
For use with:
194U-E30-1753
194U-E60-1753
194U-E100-1753
PUSH
194U-NONC
max 2
max 2
31
32
43
44
71
72
83
84
71
72
83
84
31
32
43
44
61
62
53
54
21
22
13
14
21
22
13
14
61
62
53
54
Screws must be accessible
when installed
1
SLIDE
Screws must
be accessible
when installed
1
PUSH
34
83
84
43
44
71
72
31
32
13
14
53
54
21
22
61
62
13
14
53
54
21
22
61
62
194U-NONC
max 2
83
84
43
44
71
72
31
32
Operating
switch
Operating
switch max 2
194U-NONC
2
SLIDE

194U-NO, 194U-NC
max 2
194U-NO
194U-NC max 2
1
4
21
22
31
32
3
3
13
14
43
44
max 2
194U-NO 194U-NC
max 2
1
21
22
31
32
Screws must be accessible
when installed
Screws must be accessible
when installed
For use with:
194U-E30-1753
194U-E60-1753
194U-E100-1753
For use with:
194U-A30-1753
194U-A60-1753
194U-A100-1753
194U-NO, 194U-NC
4
3
3
13
14
43
44
2
2
194U-NC 194U-NO

194U-NO, 194U-NC
194U-NO, 194U-NC
max 2
194U-NC
194U-NO
max 2
2
4
3
3
1
3
3
1
1
194U-NC
194U-NO
2
2
2
max 2
194U-NC
194U-NO
max 2
1
Screws must be accessible
when installed
Screws must be accessible
when installed
194U-NC
194U-NO
4
For use with:
194U-E160-1753
194U-E160-1754
For use with:
194U-A160-1753
194U-A160-1754
31
32
21
22
21
22
13
32
4
4
31
32
21
22
21
22
13
32
Publication
194U-IN005D-EN-E - August 2019
DIR 10002571175 Version 03)(
Copyright © 2016 Rockwell Automation, Inc. All RightsReserved. Printed in Finland .
Allen-Bradley, Rockwell Software, and Rockwell Automation are trademarks of Rockwell Automation, Inc.
Trademarks not belonging to Rockwell Automation are property of their respective companies.
Rockwell Automation maintains current product environmental information on its website at http://www.rockwellautomation.com/rockwellautomation/about-us/sustainability-ethics/product-environmental-compliance.page.