Rohde & Schwarz EFL 110 User instructions

1
> 1 sec. > 3 sec.
2
ON OFF
ANTENNA CONFIGURATION
LOADING A CHANNEL PLAN (only necessary if outside USA  default setting is FCC channel plan)
12
12
3
4
5
(Only before first use. The R&S®EFL110/210 ill keep these settings)
R&S®EFL110/210 SETTING-UP THE EQUIPMENT FOR LEAKAGE FUNCTION
Press to switch to the spectrum analyzer mode Press for more than one second
> 1 sec.
Use
to select the channel plan
Select FCC for USA and
CCIR for Europe
Press to make menu visible With select LEAKAGE->ANTENNA CONFIG.
With select ANTENNA
Use to select your antenna from the list
With select EXT. AMP.
Use to select your Ext.Am .ON from the list
With select EXT. AMP. GAIN
Use to select the gain of your antenna
Default for R&S®EFL-Z100 is Gain=12.5d
Default for R&S®EFL-Z100 is EXT. AMP. ON

Four customizable profiles
LOCALIZING THE LEAKAGE
12
1
1
2
1GETTING READY
34
2SEARCHING FOR LEAKAGE
2
&S®EFL110/210 htt ://www.rohde-schwarz.com
Connect the antenna to the F input of the
&S®EFL110/210: Press to switch on the amplifier of the R&S®EFL-Z100
antenna
Press to activate the Search Leakage Mode Move the antenna (or drive your car) until the R&S®EFL110/210
detects a leak:
After the alarm, press button. The R&S®EFL110/210 zooms
ont the frequency of the leak and activates the tone generator function
R&S®EFL110/210 LEAKAGE DETECTION IN LTE BAND (withR&S®EFL-Z100)
Press to switch to the leakage detection mode Press multiple times until the LTE band is active
Indicates LTE Band
Indicates Cable Leakage!
and soud an alarm
OPTIONAL: Press for the AUTO CONFIG. function.
It adjusts the screen for an optimum display.
This is useful after a significant change in power level.
OPTIONAL: Press to activate the F AME BEEP
The
R&S®EFL110/210 sounds a beep every time the waterfall is
refreshed.
Watch the waterfall after every beep in order not to miss anything
Move the antenna. The pitch of the tone change with the signal level.
The highest pitch means thar the antenna is pointing at the leak.
OPTIONAL: Press for >1 sec.
Use to adjust the threshold of the tone generator. The red dashed line should be higher than the highest signal peak.