3
Pressing the [MENU] button displays the menu screen. Choose the
item whose setting you want to change.
MEMO
• The values in bold are the factory default values of the VR-50HD.
Hold down [ENTER] button and press [EXIT] button to make the
value return to default. Continuing to hold down these buttons
returns related parameters displayed on the same screen to
their factory default values.
• You can change a setting value rapidly by holding down the
[ENTER] button and turning the [VALUE] knob.
• If the MEMORY screen’s “Auto Store” setting (p. 11) is set to ON, the
state in eect when you exit the menu screen is automatically
saved on the Memory No. 1.
Menu-Screen Parameter List
Audio
1–4
Parameter Value Explanation
+48 V OFF, ON You set this to ON when using a microphone that requires phantom power.
Solo OFF, ON When listening to audio through headphones, you can hear just the channels for which this value is set to ON.
Mute OFF, ON This mutes the audio on the selected channel.
Gain 0.0–+72 dB This adjusts the input gain. You can also use the [GAIN] knobs on the top panel to adjust this.
HPF OFF, ON This switches the high-pass lter (75 Hz) on and o.
Level -INF–0.0–+6.0 dB This adjusts the level sent to the MAIN bus. You can also use the channel faders on the top panel to adjust this.
Delay 0.0–500.0 ms This adjusts the amount of delay for correcting audio that is out of sync with the video (lip-sync).
AUX Send -INF–0.0–+6.0 dB This adjusts the level sent to the AUX bus.
AUX Delay 0.0–500.0 ms This adjusts the amount of delay for correcting audio and video sent to the AUX bus that are out of sync
(lip-sync).
Reverb Send 0–127 This sets the amount of reverb applied.
Pan Left, L62–L01, Center, R01–R62,
Right This adjusts the left-right balance of input.
Equalizer
ON/OFF OFF, ON This switches the equalizer on and o.
High -15–0–+15 dB This sets the gain of the high-frequency.
Frequency 700 Hz–8 kHz–11 kHz This sets the center of the frequency that will be adjusted by the High.
Mid -15–0–+15 dB This sets the gain of the middle-frequency.
Frequency 20 Hz–2.5 kHz–10 kHz This sets the center of the frequency that will be adjusted by the Mid.
Q0.5–1.0–16.0 This sets the width of the area aected by the equalizer centered at the Mid-Frequency.
Higher values will narrow the area.
Low -15–0–+15 dB This sets the gain of the low-frequency.
Frequency 55 Hz–110 Hz–800 Hz This sets the center of the frequency that will be adjusted by the Low.
Gate
ON/OFF OFF, ON This switches the gate feature on and o.
Threshold -50–-48–0 dB This sets the sensitivity at which the gate starts to be applied.
Release 30–500–5000 ms This adjusts the time from when the gate begins to function until the noise level reaches “0.”
Compressor
ON/OFF OFF, ON This switches the compressor on and o.
Threshold -50–-16–0 dB This sets the sensitivity at which the compressor starts to be applied.
Ratio 1.0: 1–INF: 1 This sets the compression ratio at which the audio signal will be compressed.
Attack 0.2–50–100 ms This sets the time from when the input level exceeds the threshold level until the compressor begins
operating.
Release 30–500–5000 ms This sets the time from when the input level falls below the threshold level until the compressor stops
operating.
