Roland XF-640 Operating manual

www.inktec.com
Roland
XF-640 Printer
InkTec SubliNova Ink User
Monthly Maintenance Guide

InkTec Monthly Maintenance Guide
InkTec Co., Ltd. 108, Neungan-ro, Danwon-gu, Ansan-si, Gyeonggi-do, 425-839, Korea www.inktec.com
02
Step 1. : Move the Head Carriage
Please follow the instructions below to move the head carriage.
After “MOVE CARRIAGE TO AVOID WIPER” is displayed,
push the head carriage to the right to move.
When the head carriage is detached, move it to the left
and prepare for the next maintenance step.
Step 2. : Cleaning the edge of a head
Coat the cotton bud or cleaning stick with SWAto clean
the edge of a head.
* If the heads are not cleaned regularly the condition
will deteriorate.

InkTec Monthly Maintenance Guide
InkTec Co., Ltd. 108, Neungan-ro, Danwon-gu, Ansan-si, Gyeonggi-do, 425-839, Korea www.inktec.com
03
Step 3. : Cleaning the Wiper
Coat the tissue paper with SWA and clean the front and back of the wipers.
* If the wipers are not cleaned regularly the nozzles can't be recovered even after cleaning.
Step 4. : Cleaning the CAP
Drop SWA down into the CAP (①) and wipe it (②) to clean the CAP (③).
* If the CAP is not cleaned for a long time, the drainage line can become clogged.
1
2
3

InkTec Monthly Maintenance Guide
InkTec Co., Ltd. 108, Neungan-ro, Danwon-gu, Ansan-si, Gyeonggi-do, 425-839, Korea www.inktec.com
04
Step 5. : NOZZLE WASH
1) Use tongs to clamp the pump line to prevent
SWA draining from the CAP.
2) Pour SWA into the top of the two clean CAPS
until full.
3) Move the head carriage to the CAP and perform a
nozzle wash for ten minutes.
Step 6. : Cleaning the Head Nozzle
1) Repeat step 1 again to move the head carriage.
2) Coat the superfine fibre cloth (lint free) to clean
the nozzles. Wipe every nozzles up and down fo
ten minutes.
* Note : Do not wipe too hard because it can
damage the nozzles.

InkTec Monthly Maintenance Guide
InkTec Co., Ltd. 108, Neungan-ro, Danwon-gu, Ansan-si, Gyeonggi-do, 425-839, Korea www.inktec.com
05
Step 7. Checking the nozzle
Return the head carriage where it was.
Perform cleaning and check the nozzles.