ROOMS TO GO 1708-4 User manual

QTY.
DESCRIPTION
NO
AHEADBOARD 1
B
HEADBOARD BASE 1
C FOOTBOARD 1
COMPONENT LIST
HARDWARE LIST IN HEADBOARD & FOOTBOARD
QTY.
DESCRIPTION
NO
1WASHER+LOCK WASHER 12
2 ALLEN BOLT (6x30mm-Thread count 28)
1
D SIDE RAIL 2
E SLATS 5
F CENTER LEG 10
3
ALLENKEY (5mm) 1
4
SCREW 10
GBHS
ASSEMBLY INSTRUCTION
1708-4 / 1708-8 / 1708-9 KING BED SKU# 32417087 / 32817085 / 32917087
This product is manufactured by Rishabh Handicrafts for ROOMS TO GO
THANK YOU FOR PURCHASING THIS QUALITY PRODUCT. BE SURE TO CHECK ALL PACKING MATERIAL CAREFULLY
FOR SMALL PARTS. WHICH MAY HAVE COME LOOSE INSIDE THE CARTON DURING SHIPMENT. IDENTIFY AND COUNT
ALL PARTS AND COMPARE WITH THE HARDWARE LIST BELOW.
12
5
ALLENKEY (4mm)
6
SCREW DRIVER (NOT INCLUDED) -
B
A
D
D
C
E
F

STEP-1
STEP-3
D
D
C
ASSEMBLE HEADBOARD FRAME
TO BASE. LOOSELY INSERT ALL
12 BOLTS INTO HEADBOARD,
THEN TIGHTEN ALL BOLTS.
-PLACE HEADBOARD ON A CLEAN AND SMOOTH
SURFACE SUCH AS A RUG OR CARPET TO AVOID
THE HEADBOARD SURFACE FROM BEING
SCRATCHED.
STEP-2
4
ASSEMBLE HEADBOARD WITH SIDE RAIL & FOOTBOARD.
This product is manufactured by Rishabh Handicrafts for ROOMS TO GO
B
A
LOOSEN AND TIGHTEN THESE
BOLTS AS NEEDED TO ASSEMBLE
THE HEADBOARD.
A
B
C
D
D
B
A
LOOSEN PRE-PARTIALLY TIGHTENED
BOLTS, ALIGN SIDERAIL WITH BOLTS
AS SHOWN.
B
D
AFTER SIDERAIL SET IN POSITION TIGHTEN THE
BOLTS COMPLETELY.

A
STEP-4
E
ALIGN SLATS TO SIDERAIL AND SET IN POSITION
AS SHOWN.
STEP-5
5
This product is manufactured by Rishabh Handicrafts for ROOMS TO GO
D
D
B
C
AFTER INSERT SCREW AND TIGHTEN
USING A SCREW DRIVER.
D
E

A
STEP-6
E
ASSEMBLE SLATS TO SIDERAIL AND SET IN
POSITION AS SHOWN.
This product is manufactured by Rishabh Handicrafts for ROOMS TO GO
D
D
B
C
E
F
F
ALIGN SLATS BOTTOM LEGS TO MATCH
HOLES TURN LEG CLOCKWISE TO TIGHTEN
COMPLETE,REPEAT STEP FOR OTHER LEGS.
STEP-7
COMPLETE PRODUCT