ROOMS TO GO KIDS IVY LEAGUE 2.0 3462360P User manual

WARNING DANGER
Failure to follow these warnings and assembly instructions could result in serious
injury or death. To help prevent serious or fatal injuries from entrapment or falls:
-
Read all instructions before assembling bunk bed and keep these instructions for future reference.
-
Before each usage or assembly, inspect bunk bed for damaged hardware, loose joints, missing
parts, or sharp edges. DO NOT Use bunk bed if any parts are missing or broken.
-
DO NOT Use substitute parts. Contact your local Rooms To Go or visit www.ROOMSTOGO.COM
for replacement parts and instructional literature if needed.
-
Follow the information on the warnings appearing on the upper bunk end structure and on the carton,
DO NOT REMOVE WARNING LABEL FROM BED.
-
Always use the recommended size mattress or mattress supports, or both to help prevent the likelihood
of entrapment or falls.
-Ensure thickness of mattress and foundation combine does not exceed 10 inches (255mm) and
mattress surface is at least 5 inches (127mm) below upper edge of guardrails.
-
Do not allow children under 6 years of age to use the upper bunk.
-
Periodically check and ensure that the guardrail, ladder, and other components are in their proper
position, free from damage, and that all connectors are tight.
-
Do not allow horseplay on or under the bed and prohibit jumping on the bed.
-
Limit top bunk use to one person.
-
Always use the ladder for entering and leaving the upper bunk.
-
Use of night light may provide added safety precaution for a child using the upper bunk.
-
Always use guardrails on both long sides of the upper bunk. If the bunk bed will be placed next to
the wall, the guardrail that runs the full length of the bed should be placed against the wall to
prevent entrapment between the bed and wall.
-
The use of water or sleep flotation mattress is prohibited.
-
This bunk bed meets all the requirements of ASTM 1427-19.
STRANGULATION HAZARD:
Never attach or hang items to any part of the bunk bed that are not designed for
use with the bed; for example, but not limited to, hooks, belts, and jump ropes.
IVY LEAGUE 2.0 COLLECTION
THANK YOU FOR YOUR PURCHASE
1/12/2021 Page 1 of 72

CONFIGURATIONS
Choose your configuration, read all the instructions, identify all components, and be sure you have all parts prior to assembly
Reference page 4-6 for assembly steps Reference page 7-9 for assembly steps Reference page 10-12 for assembly steps
TWIN/TWIN BUNK FULL / FULL BUNK TWIN / TWIN STEP BUNK
3462360P WALNUT 3461326P WHITE 3472360P WALNUT 3471326P WHITE 3482360P WALNUT 3481326P WHITE
Reference page 13-16 for assembly steps Reference page 17-20 for assembly steps Reference page 21-24 for assembly steps
FULL / FULL STEP BUNK BED TWIN / TWIN LOFT W/CHEST TWIN / FULL LOFT W/CHEST
3492360P WALNUT 3491326P WHITE 3512360P WALNUT 3511326P WHITE 3522360P WALNUT 3521326P WHITE
Reference page 25-28 for assembly steps Reference page 29-33 for assembly steps Reference page 34-38 for assembly steps
TWIN/TWIN LOFT W/2 CHEST FULL/TWIN LOFT W/CHEST-BOOKCASE FULL/FULL LOFT W/CHEST-BOOKCASE
3532360P WALNUT 3531326P WHITE 3552360P WALNUT 3551326P WHITE 3562360P WALNUT 3561326P WHITE
1/12/2021 Page 2 of 72

CONFIGURATIONS
Choose your configuration, read all the instructions, identify all components, and be sure you have all parts prior to assembly
Reference page 39-42 for assembly steps Reference page 39-44 for assembly steps Reference page 45-48 for assembly steps
TWIN/TWIN STEP LOFT W/CHEST TWIN/TWIN STEP LOFT W/CHEST-DESK ATTACHMENT TWIN/FULL STEP LOFT BED W/CHEST
3592360P WALNUT 3591326P WHITE 3602360P WALNUT 3601326P WHITE PENDING WALNUT PENDING WHITE
TWIN/FULL STEP LOFT W/CHEST-DESK ATTACHMENT
FULL/TWIN STEP LOFT W/CHEST-BOOKCASE
FULL/TWIN STEP LOFT W/CHEST-BOOKCASE-DESK ATTACHMENT
Reference page 45-50 for assembly steps Reference page 51-68 for assembly steps Reference page 51-60 for assembly steps
3622360P WALNUT 3621326P WHITE 3652360P WALNUT 3651326P WHITE 3662360P WALNUT 3661326P WHITE
FULL/FULL STEP LOFT W/CHEST-BOOKCASE
FULL/FULL STEP LOFT W/CHEST-BOOKCASE-DESK ATTACHMENT
Reference page 61-68 for assembly steps Reference page 61-70 for assembly steps
3672360P WALNUT 3671326P WHITE PENDING WALNUT PENDING WHITE
1/12/2021 Page 3 of 72

TWO PEOPLE ARE NEEDED TO ASSEMBLE
DO NOT TIGHTEN COMPLETELY UNTIL ALL PIECES
P A R T S L I S T
3462360P TWIN/TWIN BUNK WALNUT
35423603 3260706 TWIN BUNKBED END
RTG SKU # STYLE # ITEM DESCRIPTION
RTG SKU # STYLE # ITEM DESCRIPTION
35423603 3260706 TWIN BUNKBED END
36723600 3260720 LADDER
3461326P TWIN/TWIN BUNK WHITE
38000232 100-645 TWIN SLAT PACK (4)
36623608 3260730 4 SIDE RLS/2 GUARD RLS
38000232 100-645 TWIN SLAT PACK (4)
36713267 3261720 LADDER
36613265 3261730 4 SIDE RLS/2 GUARD RLS
35413260 3261706 TWIN BUNKBED END
35413260 3261706 TWIN BUNKBED END
PARTS LIST QTY HARDWARE LIST QTY
38000232 100-645 TWIN SLAT PACK (4)
38000232 100-645 TWIN SLAT PACK (4)
TOOLS NEEDED
1 Pc
Allen wrench
24 Pcs
50 mm Bolts
Side rails 1" Screws
32 Pcs 2 Pcs
16 Pcs
Twin bunk bed end
24 Pcs
1 1/4" Screws
6 Pcs
Slats
5
Ladder Hook
Guardrails
ARE CONNECTED TOGETHER
12/12/2020 Page 4 of 72
Allen wrench (included)
2 Pcs
1
1 Pc
Ladder
48 Pcs
Phillips screwdriver (not included)
A
B
C
D
E

MAKE SURE ALL BOLTS ARE TIGHTENED COMPLETELY Screw ladder hooks to pre-drilled holes on top of ladder.
12/12/2020 Page 5 of 72
Install slats, one on each end, two equally spaced in the middle,
then fasten with 1 1/4" screws. Repeat step 1 & 2 for top set of side rails.
Assemble guardrails and tighten all bolts.
ASSEMBLY INSTRUCTIONS
Assemble bottom side rails.
STEP 5
STEP 4
STEP 3
B
STEP 2
B
B
A
A
A
A
B
STEP 1
C
C
C
B
A
C
A
A
C
B
A
A
A
A
A
B
A
E
D
D
E
E
D
A
B

Twin size mattress- 74" - 75" long and 37-1/2" - 38-1/2" wide
Twin size Bunkie board- 74" long and 37-1/2" wide
Full size mattress- 74" - 75" long and 52-1/2" - 53-1/2" wide
Full size Bunkie board- 74" long and 52-1/2" wide
Screw ladder to guardrail as shown.
ASSEMBLY INSTRUCTIONS
Place Bunkie boards (required, sold separately) on top of the slats
Use only correct mattress dimensions and Bunkie board:
PLEASE CONTACT YOUR RETAIL STORE WITH SERVICE OR PARTS REPLACEMENT REQUEST
12/12/2020 Page 6 of 72
STEP 7
STEP 6
D
E
E

TWO PEOPLE ARE NEEDED TO ASSEMBLE
DO NOT TIGHTEN COMPLETELY UNTIL ALL PIECES
12/12/2020 Page 7 of 72
1 Pc
Ladder
48 Pcs
Slats
5
2 Pcs
Ladder Hook
ARE CONNECTED TOGETHER
24 Pcs
1 1/4" Screws
1
6 Pcs
Side rails 1" Screws
32 Pcs
16 Pcs
Guardrails
1 Pc
Allen wrench (included)
Allen wrench
Twin bunk bed end
2 Pcs
24 Pcs
Phillips screwdriver (not included)
50 mm Bolts
PARTS LIST QTY HARDWARE LIST QTY
38300238 100-648 FULL BUNK SLATS
38300238 100-648 FULL BUNK SLATS
TOOLS NEEDED
36613265 3261730 4 SIDE RLS/2 GUARD RLS
35513262 3261704 FULL BUNK BED END
35513262 3261704 FULL BUNK BED END
3471326P FULL/FULL BUNK WHITE
38300238 100-648 FULL BUNK SLATS
36713267 3261720 LADDER
RTG SKU # STYLE # ITEM DESCRIPTION
P A R T S L I S T
3472360P FULL/FULL BUNK WALNUT
35523605 3260704 FULL BUNKBED END
38300238 100-648 FULL BUNK SLATS
36623608 3260730 4 SIDE RLS/2 GUARD RLS
35523605 3260704 FULL BUNKBED END
36723600 3260720 LADDER
RTG SKU # STYLE # ITEM DESCRIPTION
A
B
C
D
E

12/12/2020 Page 8 of 72
then fasten with 1 1/4" screws Repeat step 1 & 2 for top set of side rails
Assemble guardrails and tighten all bolts.
MAKE SURE ALL BOLTS ARE TIGHTENED COMPLETELY Screw ladder hooks to pre-drilled holes on top of ladder
ASSEMBLY INSTRUCTIONS
Assemble bottom side rails.
Install slats, one on each end, two equally spaced in the middle,
STEP 5
STEP 4
STEP 3
B
STEP 2
B
B
A
A
A
A
B
STEP 1
C
C
C
B
A
C
A
A
C
B
A
A
A
A
A
B
A
E
D
D
E
E
D
A
B

Twin size mattress- 74" - 75" long and 37-1/2" - 38-1/2" wide
Twin size Bunkie board- 74" long and 37-1/2" wide
Full size mattress- 74" - 75" long and 52-1/2" - 53-1/2" wide
Full size Bunkie board- 74" long and 52-1/2" wide
12/12/2020 Page 9 of 72
Screw ladder to guardrail as shown.
Place Bunkie boards (required, sold separately) on top of the slats
Use only correct mattress dimensions and Bunkie board:
PLEASE CONTACT YOUR RETAIL STORE WITH SERVICE OR PARTS REPLACEMENT REQUEST
ASSEMBLY INSTRUCTIONS
STEP 7
STEP 6
D
D
D

TWO PEOPLE ARE NEEDED TO ASSEMBLE
DO NOT TIGHTEN COMPLETELY UNTIL ALL PIECES
61 Pc
Step bunk unit
5
12/12/2020 Page 10 of 72
48 Pcs
Slats
ARE CONNECTED TOGETHER
32 Pcs
16 Pcs
Twin bunk bed end
24 Pcs
1 1/4" Screws
Guardrails
Side rails Trundle bed (Optional)
TOOLS NEEDED
11 Pc
24 Pcs
Phillips screwdriver (not included)
50 mm Bolts
PARTS LIST QTY PARTS LIST QTY HARDWARE LIST QTY
1 Pc
Allen wrench (included)
Allen wrench
1 Pc
38000232 100-645 TWIN SLAT PACK (4)
35313268 3261744 TRUNDLE BED OPTIONAL
36613265 3261730 4 SIDE RLS/2 GUARD RLS
38000232 100-645 TWIN SLAT PACK (4)
35713266 3261160 STEP BUNK UNIT
35413260 3261706 TWIN BUNKBED END
35323601 3260744 TRUNDLE BED OPTIONAL
3481326P TWIN/TWIN STEP BUNK WHITE
RTG SKU # STYLE # ITEM DESCRIPTION
38000232 100-645 TWIN SLAT PACK (4)
35423603 3260706 TWIN BUNKBED END
36623608 3260730 4 SIDE RLS/2 GUARD RLS
P A R T S L I S T
3482360P TWIN/TWIN STEP BUNK WALNUT
35723609 3260160 STEP BUNK UNIT
38000232 100-645 TWIN SLAT PACK (4)
RTG SKU # STYLE # ITEM DESCRIPTION
A
B
C