ROOMS TO GO 70680802 User manual

ASSEMBLY INSTRUCTIONS
DEAR CUSTOMER,
Congratulations on your purchase of this SVLK - certified Chaise !
To assemble this furniture, you need a 16mm ( 5/8") wrench,
a screwdriver and a hammer
HARDWARE LIST
STEP 1/7
STEP 3/7
STEP 2/7
STEP 4/7
8x Dowels
Lay Chaise Frame component on level
and smooth surface, as shown. Lift the front side, then align and insert Front Leg component,
as shown. Use the color-coded sticker to guide you. Then,
insert wooden dowels into the holes by using a hammer until
the dowel is completely flushed inside the holes.
Please unpack the carton and check that you have all
component listed.
4x Stainless Steel
Screws #8 x 3
4"
Lift the rear side, then align and insert
Rear Leg component, as shown. Use
the color-coded sticker to guide you. Then,
insert wooden dowels into the holes by using
a hammer until the dowel is completely flushed
inside the holes.
2x Wheels 1x Front Leg
1x Rear Leg 1x Chaise Frame
Align the SS Plate with pre-drilled holes underneath
front leg part, then screw and tighten Screws to further
strengthen this area.
PART LIST
[MAMG][8080][PBAY SLING CHAISE]
Manufactured for Rooms to Go
[SKU:70680802]

STEP 5/7
Unpack the Wheels and unscrew all hardware from the metal threaded pin, but leave the bigger washer on,
as shown.
STEP 6/7
X
DETAIL 'X'
Insert the Wheel from outside of the Rear Leg with the bigger washer in between them. Then, insert the smaller
washer from the inner side and tighten the nut with a wrench, as shown. Repeat step to the other side.
Make sure everything has been installed correctly and the furniture is stable.
STEP 7/7
ASSEMBLY INSTRUCTIONS
[MAMG][8080][PBAY SLING CHAISE]
Manufactured for Rooms to Go
[SKU:70680802]