ROSE DISPLAYS SPIDER CEILING TRACK WITH ADHESIVE User manual

35 Congress Street, Salem, MA 01970
Tel# [phone] Fax# [phone]
e-mail:[email protected]
Parts
Step 1
Clean ceiling area and mark location
for track on ceiling.
Step 2
Peel adhesive liner off Spider Track.
Step 3
Place Spider Track on marked
ceiling location. Be sure it is
postioned correctly.
Step 4
Apply pressure along track for
1 minute, then allow adhesive to
cure for 1 hour before using track.
Note: Install OneUp anchors with
ladderless RoPole Installation Tool.
Instructions for Hanging
Spider™
Ceiling Track
with Adhesive
25-0027
Incept-5.30.01
The Spider Ceiling Track and RoPole are trademarks and OneUp is a registered
trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be
held liable for injury, loss or damage resulting from the use of these products. Part
#01INSSpider Track w/adhesive
Figure 2Figure 1
Figure 3 Figure 4
Instruction Sheet
Spider™ Ceiling Track

Parts
Step 1
Clean ceiling area and mark location
for track on ceiling.
Step 2
Peel adhesive liner off Spider Track.
Step 3
Place Spider Track on marked
ceiling location. Be sure it is
postioned correctly.
Step 4
Apply pressure along track for
1 minute, then allow adhesive to
cure for 1 hour before using track.
Note: Install OneUp anchors with
ladderless RoPole Installation Tool.
Instructions for Hanging
Spider™
Ceiling Track
with Adhesive
25-0027
Incept-5.30.01
Figure 2Figure 1
Figure 3 Figure 4
Instruction SheetSpider™ Ceiling Track
The SpiderTM Ceiling Track and RoPole are trademarks of and OneUp is a registered
trademark of Rose Displays, Ltd. Neither the manufacturer nor any sales agent may be
held liable for injury, loss or damage resulting from the use of these products.
Part #01INSSpider Track w/adhesive