ROSE DISPLAYS ANOQUICK ROUND WITH WINDOW MOUNTS User manual

35 Congress Street, Salem, MA 01970
Tel# [phone] Fax# [phone]
e-mail:[e-mail]
Parts
Instructions for Hanging
Step 1
Prepare edges of graphic by placing the graphic on
a tabletop with one edge at the table edge. Using
the AnoQuick Holder, run it across the graphic
edge, crushing it slightly. Fig. 1
Step 2
Starting at one corner, push the holder onto the
graphic. Work your way down the holder tapping
it down firmly to seat the graphic fully. Fig. 2
Step 3
Slide Window Suction Cups into the top
rail of the AnoQuick Holder. The AnoQuick
Holder is available in either a round or square
profile. Fig. 3&4
Step 4
Push end caps into place. Fig. 5
Step 5
Suspend poster. Make sure glass and suction cups
are clean and free of dust and dirt.
Important note:
For best performance when first applied and
occasionally thereafter, press the middle of the
cup (on the cap) to “burp” extra air out.
End Caps
06-5525
Note: Use only
with graphics
mounted on 3/16”
foamboard or other
similar thickness.
Can also use a
folded edge thinner
substrate.
Instructions for Hanging
Incept-9.12.02
Figure 2
AnoQuick
12A300
The AnoQuickTM is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoQuickWindowMounts
Figure 3
Figure 5
Figure 4
Figure 1
Sign Mounting Systems for Windows
AnoQuick™
Window
Mounts
20-0038

Parts
Instructions for Hanging
Step 1
Prepare edges of the graphic by placing the graphic
on a tabletop with one edge at the table edge.
Using the AnoQuick Holder, run it across the
graphic edge, crushing it slightly. Fig. 1
Step 2
Starting at one corner, push the holder onto the
graphic. Work your way down the holder tapping
it down firmly to seat the graphic fully. Fig. 2
Step 3
Slide the Window Suction Cups into the top rail
of the AnoQuick Holder. The AnoQuick holder
is available in either a round or square profile.
Fig. 3&4
Step 4
Push end caps into place. Fig. 5
Step 5
Suspend poster. Make sure glass and suction cups
are clean and free of dust and dirt.
Important note:
For best performance when first applied and
occasionally thereafter, press the middle of the
cup (on the cap) to “burp” extra air out.
End Caps
06-5525
Note: Use only
with graphics
mounted on 3/16”
foamboard or other
similar thickness.
Can also use a
folded edge thinner
substrate.
Instructions for Hanging
Incept-9.12.02
Figure 2
AnoQuick
12A300
The AnoQuickTM is a trademark of Rose Displays, Ltd. Neither the
manufacturer nor any sales agent may be held liable for injury, loss or
damage resulting from the use of these products.
Part #02INSAnoQuickWindowMounts
Figure 3
Figure 5
Figure 4
Figure 1
Sign Mounting Systems for Windows
AnoQuick™
Window
Mounts
20-0038