Rotolight SmartSoft™ Box
Installation Guide
1. The SmartSoft™ Box is
compatible with the AEOS 2 and
AEOS 2 Pro.
2. Update your AEOS 2 or AEOS
2 Pro to the latest firmware
www.rotolight.com/support
4. Turn off the AEOS 2/AEOS
2 Pro and remove the Standard
Diffuser or Barndoors if they are
installed.
5. Attach the SmartSoft™ Box
and secure with the small knob,
don’t fully tighten at this point.
NOTE – if you have the AEOS Yoke installed
loosen the larger knobs before installing the
SmartSoft™ Box and small knob.
6. Install the 2x Large M8 knobs
and fully tighten then and the
small knob.
NOTE – if you have the AEOS Yoke
installed now tighten the larger knobs
and small knob.
3. You’ll need the Rotolight
SmartSoft™ Box, 1x Small 1/4”
knob and 2x Large M8 knobs.
NOTE – if you are using the AEOS yoke you
do not need the 2x Large knobs Supplied
with the SmartSoft™ Box.
