Safavieh Furniture Bali SEA8035 User manual

PIECE QUANTITY
A 2X
B 1X
C 1X
Model # SEA8035
Part List and Hardware List
Product Dimensions : 23.2"W x 39.3"D x 38.1"H
BACK PART
SEAT PART
FOOT STEP
PICTURE
ARM PART ( RIGHT and LEFT )
CARE AND MAINTENANCE
Always use felt pads under all articles to prevent discoloration or softening of the
lacquer. Plastic and rubber bases on items can discolor wood. Wipe up spills
immediately and avoid common hazards such as hot dishes, harsh solvents and
abrasives. Cleaning should be done with a soft lint free cotton cloth dampened with
water or furniture polish. On highly used surfaces we recommend applying a quality
paste wax which should be used on a regular basis to provide additional protection
from sratches and spills. How often you apply the wax depends on how much wear
the furniture receives.
NOTICE
* Please make sure that you have all parts indicated before you begin assembly of
this item
* This item should be assembled on a soft surface to prevent scratching the finish
during assembly
* This item may require periodic tightening
DESCRIPTION
C 1X
D 1X
E
1X
F 16X
G1 2X
G2 10
G3 4X
H 1X
BOLT JCBC 6 x 40
SEAT PART
FOOT STEP
BACK SUPPORT
WOODEN DOWEL
BOLT JCBC 6 x 70
L-KEY
BOLT JCBC 6 x 50

Step 1 Step 2
PREPARATION
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list and
hardware contents list.
If any part is missing or damaged, do not attempt to assemble the product.
Estimated Assembly Time: 10 minutes.
1. Take out all the packaging from the part of the chair.
2. Take A1 part to be joined with B, C part and screw them
with the Bolt G2
1. after the all the part are assembled then fix the Foot step ( D ) part
with the BOLT G3.
Step 1 Step 2
3. Take the part of A2 and joined it to be one unit of the chair,
screw with the BOLT G2.
Step 3
1. do not forget to fix the Back suport, ( E ) to be fixed with
BOLT G3. to support the back part of the chair.
1. Take out all the packaging from the part of the chair.
2. Take A1 part to be joined with B, C part and screw them
with the Bolt G2
1. after the all the part are assembled then fix the Foot step ( D ) part
with the BOLT G3.
1. do not forget to fix the Back suport, ( E ) to be fixed with
BOLT G3. to support the back part of the chair.