Safavieh De Luca KNT4106 User manual

NOTICE
*Please make sure that you have all parts indicated and they are in good condition before you
begin assembly of this item. Refer to part list and hardware list below for guidance.
*This item should be assembled on a soft surface to prevent scratching the finish during
assembly.
*This item may require periodic tightening.
* If you are having difficulty, our friendly Customer Care team is always here to help. Please
email [email protected]
Model# KNT4106
Product Dimensions: 22”W*29”D*39”H
* Before beginning assembly of product, make sure all parts are present. Compare parts with
part contents list and hardware contents list.
*If any part is missing or damaged, do not attempt to assemble the product.
*Estimated assembly Time: 15 minutes.
*Tools Required for assembly (included): Allen Key
CARE AND MAINTENANCE
Spot clean using a mild water-free solvent. Only a professional cleaner should undertake
a complete overall cleaning.
The use of steam or water-based cleaners may cause excessive shrinking or staining.
PIECE DESCRIPTION PICTURE QUANTITY
A Seat 1x
B Front leg 2x
C Back leg 2x
HW1 Screws
6*1*80mm 8x
HW2 Flat Washer
9mm 8x WARNING
HW3
Split Lock washer
9mm
8x Weight Capacity-275LBS
HW4 Foot glide
25mm 4x Warning:Do not stand on chair
HW5 Allen Key 1x Warning:Do not over torque bolts
PREPARATION
Parts List and Hardware List

* Before beginning assembly of product, make sure all parts are present. Compare parts with
part contents list and hardware contents list.
*If any part is missing or damaged, do not attempt to assemble the product.
*Estimated assembly Time: 15 minutes.
*Tools Required for assembly (included): Allen Key
* If you are having difficulty, our friendly Customer Care team is always here to help. Please
email [email protected]
STEP3: INSERT THE FRONT LEGS(B) AND SCREW IN
THE BOLTS BUT DON'T TIGHTEN COMPLETELY.
STEP4: INSERT THE BACK LEGS(C) AND SCREW IN THE BOLTS
BUT DON'T TIGHTEN COMPLETELY.
STEP5: PUT THE CHAIR UPRIGHT AND MAKE SURE ALL
LEGS ARE LEVEL, THEN FIRMLY TIGHTEN BOLTS WITH
ALLEN KEY(HW4) WHILE THE CHAIR IS UPRIGHT AS
PICTURED ABOVE.
STEP6:CLOSE THE ZIPPER ON THE UNDERSIDE OF THE
SEAT, THIS ITEM MAY REQUIRE PERIODIC
TIGHTENING.
PREPARATION
STEP1: OPEN THE ZIPPER ON THE UNDERSIDE OF THE
SEAT(A) AND TAKE OUT LEGS AND HARDWARE.
STEP2: PUT THE WASHERS(HW2,HW3) ON THE
BOLT(HW1) IN THE ORDER SHOWN IN THE PICTURE.