Sam4s SPS-2000 User manual

SAM4SSPS‐2000REGISTERSETUPGUIDE
TosetuparegistersRS‐232porttosenddetail/journaldatafollowthesesteps:

1. definenewportdevice:selectdefineportfromtheSmenu.Selectaport(1‐6)bypressingthe
SerialPortbutton(topleft).Configuretheportwiththefollowingparameters:BaudRate‐9600,
Parity‐None,DataBits‐8andStopBits‐1.Setcuttingafterprintingtono.

2. configurePrinter:PressDevicebuttonontheDefinePortmenu(lowerleft).SelectPrinterasthe
Device.SelectGeneric#1astheprintertypePressOKtwice.

3. Setjournalmode:SelectSystemOptionfromthePGMmenu.SelectGeneralPrintingoptions
fromtheoptionmenu(pagedown).SelectPage#2.Setoption9–journal:realtime/batchtoreal
time.PressClosetwice.

4. DefinesystemPrinter:SelectPrinterandKVroutingfromthePGMmenu.SelectsystemPrinter
configuration.Selectanavailableprinter(1‐10).EnterprinterDescriptor.PressOK.Enter
REG#(thisregister).EnterPORT#(defineinstep1).PressCLOSE.

5. Setupdetailrouting:SelectDetailPrinterroutingfromthePrinterandKVroutingmenu.Enter
theRegister#(definedinstep4).EnterthePrinter#(definedinstep4).PressCLOSEtwice.

6. ConnectregistertoDVR:connectoneendofanullmodemcabletoProtdefinedinstep1.
ConnecttheotherendtoaserialportontheDVRserver.

Note.50feeistherecommendedmaximumlengthforastandardnullmodemcable.Greaterdistance
canbeachievedbyusinga9pinD‐subtoRJ45adapterandcat5cable.Distancesofseveralhundredfeet
canbeattained.
