Samsung YP-F1B Mounting instructions

[How to upgrade the firmware of YP-F1]
(Very Important !!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!)
You have to upgrade the firmware in recovery mode.
Please upgrade the firmware like below.
First Of all, install the upgrade program.
< Installing the program for firmware upgrading >
1. Extract files from "ZIP"file.
2. Execute "setup.exe" and install the program.
If the program is installed already, the installer ask whether uninstalling or not.
You have to uninstall the program and reinstall the program. Click the "Uninstall" button.
(If there is no experience for the program, go to number 4.)
3. Finishing the "uninstall" job and execute "setup.exe" to install the program.
4. Select "next" continuously for Installing the program
Now Install the firmware of YP-F1.
(Save the important data to the other storage before upgrading the YP-F1!!)
< Upgrading the firmware >
1. Connect YP-F1 to the PC. If USB device is connected, disconnect the "removable disk" safely.
2. While pressing the "Play" button, execute "Reset" button on the side of YP-F1.You have to press
the "Play" button continuously.
3. Execute the "YP-F1 Updater" for upgrading the firmware. You have to press the "Play" button
continuously.(Normally it takes 10 seconds.)
In case of searching device driver, it needs more time. Please wait.
("YP-F1 Updater" is on Desktop or "Start
→
Programs
→
Samsung YP-F1
→
YP-F1 Updater")

4. If "YP-F1 Updater"'s progressive bar is gone by(There is some image on the LCD of YP-F1), you
can release the "Play" button.
5. If "YP-F1 Updater" is available, you have to upgrade the firmware after checking the format combo
box.
6. If "YP-F1 Updater" upgrading job is completed, close the upgrading job.
7. After disconnect the "Removable disk" safely, disconnect the USB cable of the YP-U1.
8. After Entering the YP-U1's Menu
→
Settings
→
System
→
About, check the firmware version.
9. All is done. Thank you.

FAQ)
1) It doesn't work after upgrading the firmware.
→
It is recommended to connect YP-F1 to the PC in recovery mode and upgrade the firmware.
2) While connecting USB in recovery mode, there is protocol error..
→
Use the rear USB port of the PC for connecting USB.
(It is recommended for upgrading the firmware safely)