Sangean SR-2 - MANUAL 2 User manual

SR-2
User Manual

EARPHONES
1.VOLUME KNOB
2.POWER OFF/POWER ON/DBB(DEEP Bass Boost)SWITCH
3.EARPHONE JACK
4.TUNING KNOB
5.AM/FM/FM/STEREO BAND SELECTOR
6.DIAL POINTER
7.BATTERY COMPARTMENT
The battery cover is located on the left side of the unit.
Open it by sliding it in the direction of the arrow.
Insert one AAA(UM-4) size battery in the battery compartment
An earphone jack is located on the right side of the radio.
Plug the earphones supplied with the unit into this jack to hear the
program.
The earphones also act as the FM antenna when plugged into the
earphones jack. There is a separate antenna built into the radio for
AM signals, position the radio for best reception.
Turn on the radio by switching the power switch to the On position.
While using earphones you may also set the switch to DBB position to
have a stronger sound bass.
LOCATION CONTROLS.
POWER SUPPLY
7
3
ANTENNA
POWER OFF/POWER ON/DBB
(Deep Bass) SWITCH
2
TUNING KNOB 2

TUNING KNOB
Turn the tuning knob slowly to select the desired station.
Adjust the volume knob by rotating it clockwise for a
comfortable listening level.
Whenever th AM or FM frequency is tune in, the dial pointer
will correspond to the dial scale on the front of the radio.
this switch selects the AM broadcast band or the FM
broadcast band as indicated. While receiving FM broadcasting,
set the switch to FM STEREO at normal time, if the signal
becomes weak and distorted, you may select MONO mode
by switching to FM position.
Power Supply: : 1xAAA(UM-4)battery
Frequency : AM 530-1710kHz
FM 87.5-108.0MHz
Semiconductors : 3 Integrated Circuits 3 Diodes
Output Power : 0.5mW
Earphone jack : 3.5 32ohm (STEREO)
Design and specifications are subject to
change without prior notice.
4
VOLUME KNOB
1
DIAL POINTER
6
AM/FM/FM STEREO BAND SELECTOR
5
SPECIFICATIONS
3