Sanyo POA-MD17SDID User manual

HD&SD-SDI MODULE CARD
POA-MD17SDID
INSTRUCTIONS MANUAL
This module card can be used to display the
date which is converted a HD-SDI signal
(HD Serial Digital Interface Signal)
conforming to the BTA S-004 SMPTE292M
standard or the SD(D1)-SDI signal (SD
Serial Digital Component Signal) conforming
to the SMPTE259M-C standard into a RGB
parallel digital signal.
This module card is only used for our LCD
projector that has a slot for a digital card.
Contact a sales dealer for suitable
projectors.
1AA6P1P4380--(IDNN)Printed in Japan

■ Available signal format
SMPTE259M-C Standard 480-60i (60/59.94Hz)
SMPTE259M-C Standard 575-50i (50Hz)
SMPTE260M Standard 1035-60i (60/59.94Hz)
SMPTE274M Standard 1080-60i (60/59.94Hz)
SMPTE296M Standard 720-60p (60/59.94Hz)
SMPTE274M Standard 1080-24psf (24/23.97Hz)
SMPTE274M Standard 1080-24p (24/23.97Hz)
SMPTE274M Standard 1080-25psf (25/24.97Hz)
SMPTE274M Standard 1080-25p (24/24.97Hz)
SMPTE274M Standard 1080-30psf (30/29.97Hz)
SMPTE274M Standard 1080-30p (30/29.97Hz)
SMPTE274M Standard 1080-50p (50Hz)
■ Specifications of Input/Output (HD&SD-IN 1 and 2, SD-OUT)
Signal
Terminal
BTA S-004 SMPTE292 conformed,
HD-SDI 1.485GHz or 1.483GHz
BNC 75Ω,
✻For vertical frequency of 60 or 59.94, 24 or 23.97 automatically detected.
Note: These above signal formats can be available for a module card. There
are some LCD projectors does not support these signal formats. For
further details, contact a sales dealer.
Signal
Terminal
SMPTE259M-C conformed,
SD-SDI D1 270MHz
BNC 75Ω,
SD-SDI-IN, SD SDI-OUT
HD-SDI-IN
Signal
Terminal
BTA S-004 conformed,
HD-SDI 1.485GHz or 1.483GHz
BNC 75Ω,
HD SDI-OUT

■ Setup the Module card
This module card connects to the terminal slot of the LCD projector.
1. First, remove a terminal equipped with a slot for setup.
Remove 2 screws and pull out the terminal from the projector.
2. Put a HD&SD-SDI module card in along the guide, and push in the projector.
Connect the socket of module card in the terminal socket of the projector firmly.
Fasten the module with two screws.
GUIDE
SOCKET
SCREW
MODULE CARD
SCREW

Connect a cable of BNC signal to the SDI-IN 1 or SDI-IN 2.
Connect the SDI-OUT to other monitor or other projector equipped with HD-SDI or
SD-SDI module card.
■ Connection
Connect to a signal source.
(HD-SDI or SD-SDI signal)
Connect to the monitor or
other projector which is
supported the HD-SDI or
SD-SDI.
SDI IN 1 SDI OUT
SDI IN 2