Sarstedt Microvette 100 ml User manual

Microvette®100/200
User Guide
All patient blood specimens should be
treated with standard precautions.
Wear gloves!
1. Collect blood with the assembled
End-to-End 100 μl or 200 μl capillary.
For collection, best results are achieved
if the Microvette®is held in horizontal or
slightly inclined position.
During blood collection, hold the capillary
3 to 5 mm away from the puncture site.
2. Collection is complete when the
End-to-End capillary is entirely filled
with blood.
3. Hold the tube upright to allow the blood
to flow from the capillary into the
Microvette®.
4. Turn the cap to remove and discard the
preassembled capillary as one unit.
5. Remove the cap from the base and seal
the Microvette®(’click’ position).
6. Mix sample thoroughly by inverting
the Microvette®.
1
2
34
5 6
264_d_haha_microvette_GB_0316.pdf 1 11.03.16 14:30

264d-200 This document may contain information on products that may not be available in particular countries Technical modifications reserved
Microvette®300/500
User Guide
1. Turn the cap to remove it from the
Microvette®.
2. Attach the cap to the base of the
Microvette®.
3. Collect blood by gravity-flow using
any part of the collection rim.
4. Remove the cap from the base and
seal the Microvette®(’click’ position).
5. Mix sample thoroughly by inverting
the Microvette®.
1 2
3
4 5
All patient blood specimens should be
treated with standard precautions.
Wear gloves!
SARSTEDT AG & Co.
P.O. Box 12 20
D-51582 Nümbrecht
Phone [phone] - 0
Fax [phone] - 3992
[email protected]
www.sarstedt.com
264_d_haha_microvette_GB_0316.pdf 2 11.03.16 14:31