Satel MAGENTA User manual

®
MAGENTA
DIGITAL GLASS-BREAK DETECTOR
magenta_en 03/13
The MAGENTA detector enables detection of plate, tempered or laminated glass breaking.
The detector will report the alarm when a low frequency sound (impact) followed by a high
frequency sound (glass-break) are registered. The high-frequency channel is analyzed for
four seconds from receiving the low-frequency sound wave.
1. Features
Advanced dual path signal analysis.
Stepless regulation of detection sensitivity.
Low supply voltage signaling (voltage drop below 9 V ±5%).
LED indicator.
Tamper protection in 2 ways – cover removal and tearing enclosure from the wall.
2. Electronics board
terminals:
+12V - power input +12 V DC (±15%);
COM - common ground;
TMP - tamper output (NC),
NC - alarm output (NC).
tamper contact.
red color LED to indicate
detection of low-frequency sound – ON for 0,5 seconds;
alarm – ON for 2 seconds;
test mode – short flash every 3 seconds;
low supply voltage – ON.
detector configuration pins:
TEST – enabling/disabling the test mode. In the test
mode, the detector reports an alarm when it detects a
high frequency sound. The INDIGO TESTER is
recommended to test the detector. The test mode is
enabled when the jumper is set in ON position (Fig. 2).
LED – enabling/disabling the LED indicator. The LED
indicator is enabled when the jumper is set in ON
position (Fig. 3).
potentiometer for the adjustment of detection sensitivity
(Fig. 4).

2 MAGENTA SATEL
3. Installation
Disconnect power before making any electrical connections.
The detector should be installed indoors, in spaces with normal air humidity. The protected
glass surfaces must be within the detector operating range. Please note that shades,
curtains, furniture upholstery, acoustic tiles, etc. absorb the sound and adversely affect the
detector operating range.
1. Open the detector enclosure.
2. Make the opening in the enclosure base for the cable.
3. Pass the cable through the prepared opening.
4. Using wall plugs (screw anchors) and screws, fasten the enclosure base to the mounting
surface.
5. Configure the detector using jumpers and the potentiometer.
6. Connect the wires to the corresponding terminals on the electronics board.
7. Close the detector enclosure.
4. Specifications
Supply voltage ................................................................................................... 12 V DC ±15%
Standby current consumption ........................................................................................... 5 mA
Maximum current consumption ....................................................................................... 10 mA
Relay contacts rated load (resistive) ............................................................... 40 mA / 16 V DC
Alarm signaling time.............................................................................................................. 2 s
Detection range........................................................................................................... up to 6 m
Environmental class according to EN50130-5 .........................................................................II
Operating temperature range..................................................................................-10...+55 °C
Enclosure dimensions................................................................................... 24 x 110 x 27 mm
Weight.................................................................................................................................40 g
The declaration of conformity may be consulted at www.satel.eu/ce
SATEL sp. z o.o.
ul. Schuberta 79
80-172 Gdańsk
POLAND
tel. + 48 58 320 94 00
[email protected]l
www.satel.eu