SBS 701 User manual

SBS
Parking Brake Alert
Kit #701 installation instructions
For FREIGHTLINER trucks
THIS SYSTEM SHOULD BE CHECKED DAILY
FOR PROPER OPERATION
1) Install the alarm module in the cab of the
vehicle, in an unobstructed location in the dash,
where the driver can easily hear it. If preferable,
use the two wire ties to attach the module securely
in place.
2) Connect the red lead FROM THE MODULE
to the door switch lead 108D with the enclosed
connector, as shown in diagrams F and H. If the
wire numbers do not match, select the wire that is
switched “ON” when the door is opened.
3) Drill a 15/64 inch (5.59 mm) hole in the dash
in a conspicuous location with an unobstructed
view from the driver and install the flashing red
indicator LED and the warning label per diagram
“H”.
4) Connect the RED lead from the LED to the
ORANGE lead from the module and the BLACK
lead from the LED to the green wire from the
module; diagram “H.”

5) Remove the backing from the “Set Parking
Brake” washer and install the washer around the
LED.
6) Connect black wire from the module to frame
ground.
7) Locate the parking brake air line as shown on
the enclosed diagrams G. Insure you have the
correct line. (The line should have pressure on it
when the parking brake is released and no pressure
when the parking brake is set). If these conditions
exist, cut the line, and splice in the slip-fit “T”
supplied in the kit.
8) Plug the 5/32 tube from the module in to the
“T” after threading it through the dash/firewall.
9) Test the unit by opening the door with the
parking brake released. The alarm and the light
should activate, then de-activate when the door is
closed or the brake is set. With the door closed, the
alarm should not sound, with or without the brake
set.
FOR TECH SUPPORT OR QUESTIONS, CALL
1-800-789-5886
or 503-873-4418

Parts list for Freightliner
Kit 701
Parts contained in this kit:
5 Female connectors
10 Male connectors
1 Ring connector
1 wire tap
Warning label
LED
12 inches green wire
12 inches orange wire
36 inches red wire
18 inches black wire
1 Slip-fit Tee
SBS module with alarm attached
2 wire ties
Installation instructions
Manufactured and sold by:
Safety Brake Set Inc.
3508 Cascade Hwy N.E.
Silverton, OR 97381
1-800-789-5886
[email protected]