Schumacher Electric SE-1 User manual

1-Amp Trickle Charge –120V plug-in
Manual Operation
Reverse-Hookup Protection
Convenient 12-Foot Power Cord
Applications –Charge small batteries,
keep larger batteries warm in cold temperatures.
Plug-In Wall Battery Charger
Model SE-1

1.5-Amp Trickle Charge –120V plug-in –charges
in 2 to 12 hours
LEDs -indicate Power On and Charged
Fully Automatic –once battery is charged, unit
switches from full charge to float-mode monitoring
“On-Board” Feature – comes complete with
hardware & bracket to mount charger next to
battery
Reverse-Hookup Protection
Molded Plastic Case
Short Leads For Safety –minimize chance of
getting tangled in moving engine parts
Mountable Maintainer
Model SE-1-12S

1-Amp Trickle Charge –120V plug-in,
Manual Operation
50-Amp Clamps
Quick-Disconnect Harness
Utilize ring connector and only hook harness
up once
No need to remove battery again to charge
Both the 50-Amp clamp & ring connectors
snap into place in seconds
Reverse-Hookup Protection
Molded Plastic Case
Battery Charger
Model MC-1

Manual Operation
Rugged Durable Metal Case
Top Mounted Carrying Handle
Metal Hand-Held Linear Battery Charger
Model SE-82-6
6-Amp Medium Charge –charges
most batteries in 6 to 8 hours
2-Amp Trickle Charge –charges a
small 12 volt battery in 2 to 12 hours
10-Amp Fast Charge –charges a
battery in 3 to 5 hours
2-Amp Trickle Charge –charges a
small 12 volt battery in 2 to 12 hours
Model SE-1010-2

Fully Automatic/Manual
Operations
Rugged Durable Metal Case
Top Mounted Carrying Handle
Metal Hand-Held Linear Battery Charger
Model SE-40MAP
10-Amp Fast Charge –charges a
battery in 3 to 5 hours
Model SE-520MA
10-Amp Fast Charge –charges a
battery in 3 to 5 hours
2-Amp Trickle Charge –charges a
small 12 volt battery in 2 to 12 hours
LED- shows Fully Charged

Manual Operation
Rugged Durable Metal Case
Top Mounted Carrying Handle
Metal Hand-Held Linear Battery Charger/Starter
Model SE-1052
50-Amp Engine Start –for emergency
starting
10-Amp Fast Charge –charges a battery
in 3 to 5 hours
2-Amp Trickle Charge –charges a small
12 volt battery in 2 to 12 hours
Model SE-1250
50-Amp Engine Start –for
emergency starting
30-Amp Boost –for quick charges
10-Amp Fast Charge –charges a
battery in 3 to 5 hours

Fully Automatic
2 LEDs
Rugged Durable Metal Case
Top Mounted Carrying Handle
Metal Hand-Held Linear Battery Charger/Starter
Model SE-1510MA
100-Amp Engine Start –for
emergency starting
15-Amp Fast Charge –charges a
battery in 2 to 4 hours
2-Amp Trickle Charge –charges a
small 12 volt battery in 2 to 12
hours
Model SE-5212A
50-Amp Engine Start –for
emergency starting
10-Amp Fast Charge –charges
a battery in 3 to 5 hours
2-Amp Trickle Charge –
charges a small 12 volt battery in
2 to 12 hours
Model SE-1275A
75-Amp Engine Start –for
emergency starting
12-Amp Fast Charge –
charges a battery in 2 to 5
hours
2-Amp Trickle Charge –
charges a small 12 volt battery
in 2 to 12 hours

125-Amp Engine Start –for emergency
starting
15-Amp Fast Charge –charges a battery in
2 to 4 hours
2-Amp Trickle Charge –charges a small, 12
volt battery in 2 to 12 hours
6-Function Rotary Switch
Metal Hand-Held Linear Charger/Starter
Model SE-125A
Fully Automatic/Manual
Operation
2 LEDs
Rugged Durable Metal Case
Top Mounted Carrying Handle
Model SE-2151MA
100-Amp Engine Start –for emergency
starting
15-Amp Fast Charge –charges a
battery in 2 to 4 hours
2-Amp Trickle Charge –charges a
small 12 volt battery in 2 to 12 hours

10-Amp Fast Charge –
Charges a deep-cycle battery in 7 to 11 hours.
Charges an automotive battery in 3
to 5 hours
Flexible Function –select manual or fully
automatic function for special applications
Fully Automatic - once battery is charged,
unit switches on and off as needed
Rugged Durable Metal Case
Top Mounted Handle
Metal Hand-Held Linear Charger/Starter
Model SE-70MA

10 or 5-Amp Charge Rate
Manual Operation
Rotary Switch Selection
Includes 5 Jumpers –for connecting
batteries in series
Charge Up to Six 12V or Twelve 6V
Batteries
Dual-rate Output
Safety –has overload & short-circuit
protection
Rugged Durable Metal Case
Top Mounted Carrying Handle
Applications –6V & 12V batteries, hooked
up in 12, 24, 36, 48, 60 or 72 Volt
configurations
Multiple Battery Charger
Model SE-1072
12V 6V

6-Amp Medium Charge Rate –Charges a 12V
battery in 6 to 8 hours
2-Amp Trickle Charge –charges a small 12-
Volt battery in 2 to 12 hours
Manual Operation
Signature Series Linear Battery Charger
Model 82-6-PE
Rugged Polypropylene Case
Built-In Top Mounted
Carrying Handle
Model 520A-PE
10-Amp Fast Charge –charges a 12V battery in 3
to 5 hours
2-Amp Trickle Charge –charges a small 12 volt
battery in 2 to 12 hours
Fully Automatic
2 LEDs –signals Power On and Fully Charged

50-Amp Engine Start –for emergency starting
10-Amp Fast Charge –charges a 12V battery
in 3 to 5 hours
2-Amp Trickle Charge –charges a small 12V
battery in 2 to 12 hours
Fully Automatic
2 LEDs –signals Power On and Fully Charged
Signature Series Linear Battery Charger/Starter
Model 5216A-PE
Model 1050-PE
50-Amp Engine Start –for emergency starting
10-Amp Fast Charge –charges a 12V battery
in 3 to 5 hours
2-Amp Trickle Charge –charges a small 12V
battery in 2 to 12 hours
Manual Operation
Rugged Polypropylene Case
Built-In Top Mounted Carrying
Handle

1.5-Amp Charger and Maintainer
Fully Automatic –once battery is charged, unit
switches from Full Charge to Float-Mode Monitoring
Microprocessor Controlled
Automatic Voltage Detection
Automatic Temperature Compensation
Thermal Runaway Protection
Safety Start –charger will not supply current to
battery until it is properly connected to a battery.
LEDs –indicate Charging, Charged and Power
Quick-Disconnect Harness
Utilize ring connector and only hook harness up
once
No need to remove battery again to charge
Both the 50-Amp clamp & ring connectors snap
into place in seconds
Reverse-Hookup Protection
Speed Charge Maintainer
Model SEM-1562A

SpeedCharge Battery Charger
Microprocessor Controlled
LEDs Indicate –Charging, Charged and Trouble
Safety Start
Fully Automatic –once battery is charged, unit
switches from Full Charge to Float-Mode
Monitoring
Quick-Disconnect Harness -
Utilize ring connector and only hook harness
up once
The 50-Amp clamps snap into place in
seconds!
Use male adaptor plug to recharge booster
packs or
recharge vehicle battery via cigarette port
Reverse-hookup protection
Model SC-200A
2-Amp, 12V Charge –120V
plug-in, high-frequency,
automatic operation
4-Amp, 6V Charge
Model SC-300A
3-Amp Charge –120V
plug-in, high-frequency,
automatic operation

SpeedCharge Battery Charger
6-Amp Medium Charge –charger monitors battery
condition and automatically adjusts charging rate,
preventing battery damage
4-Amp Medium Charge –self-adjusting charge rate
ideal for everyday charging needs
2-Amp Slow Charge –for charging small batteries
and maintaining large ones
Fully Automatic
50-Amp Clamps –offer versatility for top & side-
mounted battery posts
Model SC-600A
Microprocessor Controlled
Thermal Runaway Protection
Safety Start
Electronic Push Button Controls
Sturdy, Built-In Handle
Molded Polypropylene Case
Model SC-1000A
10-Amp Medium Charge –charger monitors battery
condition and automatically adjusts charging rate,
preventing battery damage
6-Amp Medium Charge –self-adjusting charge rate
ideal for everyday charging needs
2-Amp Slow Charge –for charging small batteries
and maintaining large ones
Fully Automatic
Charging Status LEDs
50-Amp Clamps –offer versatility for top & side-
mounted battery posts

SpeedCharge Battery Charger
12-Amp Fast Charge –charger monitors battery
condition and automatically adjusts charging rate,
preventing battery damage
8-Amp Medium Charge –self-adjusting charge rate
ideal for everyday charging needs
2-Amp Slow Charge –for charging small batteries
and maintaining large ones
50-Amp Clamps –offer versatility for top and side-
mounted battery posts
Microprocessor Controlled
Thermal Runaway Protection
Safety Start - charger will not supply current to
battery until it is properly connected to a battery
Charging Status LEDs
Easy-Touch Controls –easy-to-feel switches for
selection of Display Mode, Charge Rate and Battery
Type
Portable & Light Weight –retractable handle for
easy portability & storage, weighs only 5.5 lbs.
Molded Polypropylene Case
Model SC-1200A

Model SC-10030A
100-Amp engine start
12 ◄►30-Amp fast charge
2-Amp Trickle Charge
SpeedCharge Hybrid Battery Charger/Starter/Tester
Microprocessor Controlled
Thermal Runaway Protection
Safety Start
Charging Status LEDs
Electronic Touch Pad Controls
125-Amp Sure-Grip Clamps
Retractable Handle
Built-In Digital Voltmeter/Tester
Molded Polypropylene Case
Model SC-8020A
80-Amp engine start
10 ◄►20-Amp fast charge
2-Amp Trickle Charge

10-Amp Fast Charge –charger monitors battery
condition and automatically adjusts charge rate,
preventing battery damage for car, truck, marine,
RV, farm equipment, AGM gel cell and deep-cycle
batteries
6-Amp Medium Charge –self-adjusting charge
rate ideal for everyday charging needs
2-Amp Slow Charge –for charging small batteries
and maintaining large ones
50-Amp Clamps –offer versatility for top and side-
mounted battery posts
SpeedCharge Ship N’ Shore High Frequency Charger
Model SSC-1000A
Microprocessor Controlled
Thermal Runaway Protection
Safety Start
Charging Status LEDs
Electronic Push Button Controls
Molded Polypropylene Case
Model SSC-1500A
15-Amp Fast Charge –charger monitors battery
condition and automatically adjusts charge rate,
preventing battery damage for car, truck, marine,
RV, farm equipment, AGM gel cell and deep-
cycle batteries
10-Amp Medium Charge –self-adjusting charge
rate ideal for everyday charging needs
2-Amp Slow Charge –for charging small
batteries and maintaining large ones
75-Amp Clamps –offer versatility for top and
side-mounted battery posts

Fully Automatic
LED Indicators
Reverse-Hookup Safeguard
Built-in Convenient Carrying Handle
Signature Series Ship N’ Shore Battery Charger
Model SS-51A-PE
10-Amp Fast Charge –ideal for
everyday charging needs
Model SS-120A-PE
12-Amp FAST Charge
Flexible Function –manual or automatic
Microprocessor Controlled

True 10-Amp Charge for–
Single 12V battery
Two 12V Batteries in a two-battery, 24-Volt
system
True 20-Amp Charge –for single 12-Volt battery
Fully Automatic
Multiple Marine Capabilities –comes complete
with two sets of output cords
Microprocessor Controlled –dedicated
processor for each independently controlled bank
Safe –ignition protected, non-sparking battery
leads allow safe charging, even on board
Electrically Independent Outputs –handle 12
or 24 volt systems
Fully Automatic –multi-stage charging system
with float-mode monitoring charges and then
maintains the battery. Resumes continuous
charging when battery becomes discharged
Applications –perfect for multiple marine
charging needs
Ship N’ Shore Battery Charger
Model SS-210A