Scosche AU2392B User manual

SCOSc::J-IE~
IN DASH INSTALLATION KIT FOR
2006 AUDI A3 VEHICLES
AU2392B
PROVIDE EASY CONNECTION OF YOUR CAR
STEREO TO FACTORY WIRING HARNESS.
VW03B
2OO2-Up Audi/BMWNolkswagen
VWA3B
1997-UpAudi; 1999-Up BMW;
2002-Up Volkswagen
-.FACTORY
WIRING CODES
.-
INTRODUCTION I PRELIMINARY
This premium installation kit is for 2006 Audi A3 vehicles. Included are all the parts you need to
mount your car stereo/cassette or CD player into your vehicle's dash. Refer to the individual
instruction in this manual to remove your vehicle's factory radio and assemble the kit.
CAUTION:
DISCONNECT YOUR VEHICLE'S NEGATIVE BATTERY TERMINAL BEFORE THE INSTALLA·
TION TO HELP PREVENT ELECTRICAL DAMAGE.
WE RECOMMEND THE USE OF AVOLT/
OHM METER OVER ATEST LIGHT TO CHECK WIRING. ATEST LIGHT OR GROUNDED WIRE
PROBE CAN CAUSE DAMAGE TO THE VEHICLE'S COMPUTER AND/OR DIAGNOSTIC
SYSTEMS. AVOID ALL FACTORY AIR
BAG WIRING· AIR BAGS CAN ACCIDENTALLY DEPLOY
CAUSING SERIOUS INJURY OR DEATH.
NOTES:
• See your vehicle's instructions for any special tools your installation might require.
•
Read all instructions accompanying your car stereo/cassette player for proper wiring and
mounting instructions.
LIABILITY DISCLAIMER
This instruction booklet is based on carefully documented data and research of automobile dash disassembly,
wire harness/codes and information pertaining
to installation of this kit (AU2392B) in 2006 Select Audi A3
Vehicles. Scosche Industries, Inc. can not be held responsible for discrepancies/inconsistencies that may occur
due to the automobile manufacturing changes or options, or damage that may occur
in the automobile during
the installation of components while using this booklet.
Ifyou have anyfurther questions. call our toll free technical helpline at: 1·800·621·3695x3
©2006 SCOSCHE INDUSTRIES, INC. Sl 8/06 -AU2392B (3000003)

RADIO REMOVAL
RADIO REMOVAL:
1. Using DT2 radio removal tools, remove the factory radio. Disconnect and remove.
ASSEMBLING THE KIT
1. Mount the aftermarket DIN stereo in the factory radio opening with the radio's
supplied mounting sleeve, but
do not bend any mounting tabs. Do not use the
stereo's trim ring. If your radio has apermanent trim ring, it will have to be cut off to
use the AU2392 Kit.
2. Snap the AU2392 panel into the radio and check for proper faceplate clearance. The
installation should appear
as an ISO mount. If the radio is set too far back, then use
the Scosche
DIN trim ring included with this kit around the radio's mounting sleeve to
space outward.
3. Once the positioning is correct, then make all wiring connections and mount radio
permanently.
RADIO'S
MOUNTNIG
SLEEVE
DIN TRIM RING/SPACER
6149 MOUNTING PANEL
2