Scosche DO2110 User manual

DO2110
IN-DASH INSTALLATION KIT FOR
1999-UP DAEWOO LANOS/LEGANZA/NUBIRA
1999-UP DAEWOO VEHICLES
(Use Scosche DO01 for Car Stereo Connector)
Power and Speaker:
1= Right Front Positive
2= Right Rear Positive
3= Illumination
4= 12V Ignition/Switched
5= 12V Battery/Constant
6= Empty
7= Left Rear Positive
8= Left Front Positive
9= Right Front Negative
10 = Right Rear Negative
11 = Empty
12 = Power Antenna
13 = Empty
14 = Chassis Ground
15 = Empty
16 = Empty
17 = Left Rear Negative
18 = Left Front Negative
• All wire codes are viewed as looking at the front of the plug with the wires exiting the rear.
• Use these wiring codes as a guide. Your vehicle might differ.
NOTES:
WIRE CODES
NOTE: • The following connectors are available to easily plug your new stereo cassette/disc player into
the factory harness.
PART #: DESCRIPTION:
DO01 1999-UP Daewoo car stereo connector
DO2110
TRIM RING
DO2110
KIT PANEL
DO2110
2 CD
POCKET
DIN RADIO INSTALLATION (DETACHABLE FACE/PULLOUT)
Slide the mounting sleeve (metal shroud) into the panel’s radio opening and bend all available mounting tabs
outward (see inset). Once the radio mounting sleeve has been fastened to the kit panel, slide the radio into
the mounting sleeve until it locks into place.
NOTE: The mounting sleeve must be removed from the radio first!
Your radio may be snapped into its sleeve. Slide the mounting
sleeve (metal shroud) off the radio towards the back.
DIN
RADIO
BEND
TABS
OUTWARD
This premium installation kit is for 1999-up Daewoo Lanos/Leganza and Nubira vehicles. Included are all of
the parts you need to mount your car stereo/cassette or CD player into your vehicle’s dash. Refer to the
individual instruction in this manual to remove your vehicle’s factory radio and assemble the kit.
CAUTION: Disconnect your vehicle's negative battery terminal before the installation to help
prevent electrical damage. We recommend the use of a volt/ohm meter over a test light to check
wiring. A test light or grounded wire probe can cause damage to the vehicle's computer and/or
diagnostic systems. Avoid all factory air bag wiring - air bags can accidentally deploy causing
serious injury or death.
NOTES:
• See your vehicle’s instructions for any special tools your installation requires.
• Read all instructions accompanying your car stereo/cassette player for proper wiring and mounting
instructions.
DO2110
MOUNTING
PANEL
RADIO
MOUNTING
SLEEVE
DO2110
TRIM RING
INTRODUCTION
KIT INSTALLATION
CAUTION:
REAR SUPPORTING THE
RADIO ADDS TO THE
INSTALLATION’S
STRUCTURAL INTEGRITY.
VARIOUS
REAR
SUPPORT
STRAPS
2 CD
POCKET

POCKET INSTALLATION
1. Locate and align bottom guides and
top snaps of the pocket to kit panel.
2. Slide pocket on bottom guides while
the top snaps are aligned.
3. When aligned properly, the top
pocket snaps will lock to kit panel.
BACK VIEW OF
MOUNTING
PANEL
BACK VIEW
OF POCKET
POCKET ASSEMBLY
CAUTION:
REAR SUPPORTING THE
RADIO ADDS TO THE
INSTALLATION’S
STRUCTURAL INTEGRITY.
1999-UP DAEWOO LANOS
RADIO REMOVAL
1. Use a flat screw driver and carefully pry
on upper left and right corners of the
lower radio trim bezel.
2. Extract (2) philips head screws from the
radio bracket. Disconnect and remove.
1999-UP DAEWOO LEGANZA
RADIO REMOVAL
NOTE: The factory stereo provision is
for a Double DIN size radio.
1. Using a small angled pick carefully pull
on far corners of the radio bezel. Extract
(4) Phillips head screws holding radio.
Disconnect and remove.
1999-UP DAEWOO NUBIRA
RADIO REMOVAL
NOTE: The factory stereo provision is
for a DIN size radio with a storage
pocket below. The actual dash
opening is a Double DIN.
1. Using a small pic carefully pry toward
you around radio dash bezel.
2. Extract (2) Phillips head screws holding
radio, disconnect and remove.
REMOVE REMOVE
BACK VIEW
SCOSCHE STEREO INSTALLATION COMPONENTS STEREO DASH KITS