Scosche MA1535 User manual

MA1535
IN-DASH INSTALLATION KIT FOR
2001-UP MAZDA TRIBUTE VEHICLES
MA1535 TRIM RING
5125 POCKET
MA1535 MOUNTING PANEL

Thank you for purchasing the Scosche MA1535 Kit. This kit was manufactured with the highest of quality
standards.
CAUTION:
Disconnect your vehicle's negative battery terminal before the installation to help prevent electrical
damage. We recommend the use of a volt/ohm meter over a test light to check wiring. A test light or
grounded wire probe can cause damage to the vehicle's computer and/or diagnostic systems. Avoid all
factory air bag wiring - air bags can accidentally deploy causing serious injury or death.
NOTES:
•See your vehicle's instructions for any special tools your installation might require.
•Read all instructions accompanying your car stereo/cassette player for proper wiring and mounting
instructions.
INTRODUCTION / PRELIMINARY
POCKET ASSEMBLY
ATTACHING THE POCKET:
Snap the pocket into place on
the back of the kit panel.
STEREO INSTALLATION
RADIO REMOVAL
1. Using a small screwdriver or pick, pry out radio removal access panels on either side of radio.
2. Using two sets of radio removal tools (DT-1) release, disconnect, and remove radio from dash.
MA1535
MOUNTING
KIT PANEL
REAR
SUPPORT
ISO
MOUNT
RADIO
MA1535 POCKET TRIM
5125 POCKET
MOUNTING THE RADIO
CAUTION:
REAR SUPPORT AVAILABLE SEPARATELY. REAR SUPPORTING THE
RADIO ADDS TO THE INSTALLATIONS STRUCTURAL INTEGRITY.
BEND TABS
OUTWARD
SCOSCHE STEREO INSTALLATION COMPONENTS STEREO DASH KITS