Sealey ARB120.V3 User manual

DO NOT use the roof bars if any parts are missing or damaged as this may cause failure or possible personal injury.
WARNING! Owing to the variety in design of vehicles it is the user's full responsibility to ensure no damage occurs whilst using these
roof bars. Correct attachment to a vehicle is therefore critical and is beyond control of the manufacturer, distributor, or supplier.
WARNING! The user must secure the roof bars properly, checking the security frequently when in use.
WARNING! Avoid any protrusions beyond the side of the car as these may present a risk of injury to passers-by.
DO NOT use the roof bars for any purpose other than for which they are designed.
WARNING! Drive carefully - Be aware of cross winds, sudden braking or hard cornering, reduce speed accordingly when roof bars
are fitted.
WARNING! These roof bars are designed for temporary use only, remove when not in use or before going through a car wash.
Before every use check the bars for security of fittings or any sign of wear and tear. Replace any worn or damaged parts.
Check the load is stable before moving off.
Be cautious of the load height and restrictions of the route(s) you will be taking.
DO NOT exceed the weight limit stated in the specifications or the vehicle handbook, whichever is lower.
WARNING! Remember the driver of the vehicle is responsible for the security and safety of the load carried.
INSTRUCTIONS FOR:
ALUMINIUM ROOF BARS 1200, 1350MM FOR
TRADITIONAL ROOF RAILS 90KG MAX LOAD
MODEL Nos: ARB120.V3, ARB135.V3
 Aerodynamicaluminiumroofbarstotontotraditionalroofrails,completewithanti-theftlocks.Availableintwolengthstosuitmost 
 vehiclesttedwithtraditionalroofrailsupto58mmwide.Maximumloadcapacity90kg.
Model No: ....................ARB120.....................................ARB135
Overall Length: .................1200mm ....................................1350mm
Maximum Load Capacity: ............90kg........................................90kg
ARB120.V3,ARB135.V3Issue:113/11/15
Original Language Version
© Jack Sealey Limited
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
1. SAFETY
2. INTRODUCTION
3. SPECIFICATION
Refer to
instruction
manual

3.2. To avoid the risk of damage to the vehicle roof, it is recommended that two people lift the roof bars into place.
3.3. Position the clamps over the roof rails and adjust the bar until it is centrally situated; take care not to let the bar protrude beyond the
outline of the vehicle.
3.4. Unlessthevehiclehandbookstatesdifferently,spacethetwobarsatleast700mmapart(fronttorear).
3.5. Wheninposition,tightentheclamps(to6Nm)asing.2.
3.6. Theclampsshouldgriptheroofrailasing.3.
3.7. As the inner jaw of the clamp tightens against the rail it will also tighten against the bar, securing it in place.
3.8. When secure, close the hex key hole shutter by turning the key clockwise and removing.
g.2 g.3
g.4 g.5 g.6
4. LOAD SECURITY
4.1. DO NOT rely on elasticated fastenings to secure loads to roof bars; use straps.
4.2. Ensure that any load or attachment is placed centrally or symetrically on the roof bars, with the centre of gravity as low as possible.
4.3. The roof bars are supplied with 4 x square headed bolts to facilitate the attachment of accessories.
4.3.1. Toattachthesebolts,rstremovethebarendcapandslideoutthellerstripasing.4.
4.3.2. Positiontheboltsintheirintendedlocation(g.5).
4.3.3. Cutthellerstripintotherequiredlengthtollthetopchanneloneithersideofthebolts.
4.3.4. Slide the bolts out.
4.3.5. Rellthetopchannelwiththellerstripandboltsintheircorrectorderasing.6.
4.3.6. RettheendcapsandsecuretheaccessorytothebarusingM6nuts(notsupplied).
 WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations that
may occur. It must be understood by the user that common sense and caution are factors which cannot be built into
this product, but must be applied by the user.
Environmental Protection.
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted,
taken to a recycling centre and disposed of in a manner which is compatible with the environment.
email
3. INSTALLATION
3.1. Beforeofferingtheroofbarstotheroofrail,openbothclampssufcientlyforthemtostraddletherail.
3.1.1. Theclampisopenedbyinsertingthehexkeyandwindinginananticlockwisedirectionasing.1.
3.1.2. The hex key opening on the locking clamp is protected by a shutter which is opened by inserting the key and turning anticlockwise.
g.1
NOTE: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior notice.
IMPORTANT: No liability is accepted for incorrect use of this product.
WARRANTY: Guarantee is 12 months from purchase date, proof of which will be required for any claim.
01284 757500
01284 703534
[e-mail]
Sole UK Distributor, Sealey Group,
Kempson Way, Suffolk Business Park,
Bury St. Edmunds, Suffolk,
IP32 7AR
www.sealey.co.uk
ARB120.V3,ARB135.V3Issue:113/11/15
Original Language Version
© Jack Sealey Limited