
OIL FILTER DRAIN TUBE - OIL FILTER DRAIN
TUBE & BOTTLE
MODEL NO: VS7010 & VS7110
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
9Keep the drain tube and bottle clean and maintain it in good condition.
9Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
9Keep all non-essential persons away from the work area.
9Check connections and fittings before use.
9Ensure that the bottle capacity exceeds the amount of fluid to be collected.
8DO NOT use for any purpose other than that for which it is designed.
8DO NOT operate if any parts are damaged or missing as this may cause failure and/or personal injury.
8DO NOT leave drain tube and bottle operating unattended.
IMPORTANT! Ensure that you wear protective clothing, gloves, goggles, face mask as appropriate for the fluid being extracted.
WARNING! DO NOT allow uncontrolled discharge of fluids thus polluting the environment.
9Dispose of waste fluids in accordance with local authority regulations.
WARNING! DO NOT use with gasoline or other flammable liquids.
8DO NOT use the unit to extract dangerous chemicals, poisons, acids, alkaline or solvents.
9The container is not designed for long term storage.
8DO NOT store the unit under extreme conditions.
8DO NOT adapt the unit for any other purpose.
9When not in use, store in a safe, dry, childproof area.
2. INTRODUCTION
ModelNo.VS7010DesignedtoattachtotheoillterhousingonVAGFSipetrolengines.Allowsthelterhousingtobedrained
beforeremoval,preventingspillage.Useinconjunctionwithasuitableoildrainer.ModelNo.VS7110Featuresacontrolvalvetted
to the bottle and hanging chain.
3. OPERATION
3.1. With the vehicle on a suitable ramp drain engine oil.
3.2. Locatetheoillter(blackplastichousing).
3.3. Remove the dust cover on the bottom of the housing to expose the red bleed valve.
3.4. VS7110 - Secure drain bottle using the retaining chain and open valve, on top of the drain bottle.
3.5. Screwtheadaptorintotheendoftheplastichousing.Screwingintheadaptorwillreleasetheredbleedvalveinthelterhousing
which allows the oil to drain.
3.6. Once fully drained unscrew adaptor.
3.7. Thelterhousingcannowberemovedfromtheengineusingthelargehexlocatedatthebottomofthelterhousing.
4. MAINTENANCE
Keep the unit clean, wipe off any fluid spillage. Keep the tubes clean and clear of blockages. Check that all tubes and connections are
in good condition.
VS7010VS7110Issue2(HF)24/08/18
Original Language Version
© Jack Sealey Limited
Refer to
instructions
VS7010
Wear eye
protection
Wear protective
gloves
Wear a mask
VS7110