Sealey DT55RCOMBO1 User manual

MOBILE DISPENSING TANK 55LTR WITH OIL
ROTARY PUMP - RED
MODEL NO: DT55RCOMBO1
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING! Ensure all Health and Safety, local authority and general workshop practice regulations are strictly adhered to when using
this equipment.
9Familiarise yourself with the applications, limitations and potential hazards of this product.
9Maintain the pump in good condition (use an authorised service agent).
9Replace or repair damaged parts. Use genuine parts only. Unauthorised parts will invalidate the warranty.
9Use only with oils, anti-freeze, degreasers and other NON-corrosive fluids.
9Ensure safety eye protection and protective clothing are worn when using this product.
9Keep the work area clean and uncluttered and ensure that there is adequate lighting.
9Maintain correct balance and footing. Ensure the floor is not slippery and wear non-slip shoes.
9Keep children and unauthorised persons away from the work area.
9Dispose of waste liquids in accordance with local authority regulations.
8DO NOT use the pump to transfer hazardous or harmful chemicals, solvents, petrol or acids.
8DO NOT use the pump with water.
8DO NOT use the pump for any purpose other than for which it is designed.
8DO NOT attempt to move the fluid drum by pulling on the pump.
9Keep the pump clean and well oiled and store in a safe, dry location when not in use.
2. INTRODUCTION
Manufactured from hard wearing and durable polyethylene. 55ltr Capacity suitable for the distribution of Diesel, Oil, AdBlue®, Water and
Antifreeze. Model No. DT55RCOMBO1 (Red) is supplied with Model No. TP55 Oil Rotary Pump, tted with two roller wheels, hose holder and
vent caps. Features a 2”BSP thread and four point screw ttings enabling other pumps to be tted as required.
3. ASSEMBLY
3.1. The bottom of the suction tube is designed to sit on the bottom of the tank without
obstructing the flow into the tube.
3.2. Pass drum adaptor over the threaded end of the suction tube. Slacken the drum adaptor
by twisting the top ring (fig.2) until it slides freely on the tube. Screw into the top of the
drum (fig.4) and tighten the top ring (fig.3).
3.3. Attach the bracket the top set of nuts moulded into the plastic. DO NOT fully tighten the
screws just yet (fig.4).
3.4. Attach the other half of the bracket capturing the suction tube (fig.6), tighten the screws.
3.5. Screw the pump body onto the suction tube, it is advised that you hold the tube while
screwing the pump onto it.
3.6. Attach the handle and secure it by screwing the bolt onto the at (g.5).
g.1
g.2
g.3
g.4
DT55RCOMBO1 Issue 1 21/12/18
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear eye
protection
Wear protective
gloves

4. MAINTENANCE
6.2. Check the tightness of all ttings regularly and tighten if necessary.
6.3. Keep the pump unit clean to highlight any leaks which may develop in service.
5. TROUBLESHOOTING
PROBLEM PROBLEM POSSIBLE CAUSE SOLUTION
Low or no ow rate. Low level in source tank. Rell the tank.
Air entering the pump or suction tube. Check seals and connections.
Leakage from the body pump. Seal damaged. Contact your authorised Sealey stockist.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 [e-mail] www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
Parts support is available for this product. To obtain parts, please log on to
www.sealey.co.uk, email [e-mail] or telephone [phone]
FLAT
g.5
g.6
g.7
DT55RCOMBO1 Issue 1 21/12/18
Original Language Version
© Jack Sealey Limited