Sealey LAD002 User manual

LADDER STAND-OFF
MODEL NO: LAD002
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLYAND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURYAND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING! Take care when using and moving ladders in the vicinity of power cables - risk of potentially fatal electric shock.
WARNING! Ensure Health and Safety, local authority, and general workshop practice regulations are adhered to when using
this equipment.
9 Familiariseyourselfwiththeapplicationandlimitationsoftheladderstand-o󰀨,aswellasthepotentialhazards.
9Maintain the equipment in good condition.
9Replace or repair damaged parts. Use genuine parts only. Unauthorised parts may be dangerous and will invalidate the warranty.
WARNING! Use ladder on level and solid ground and either have an assistant stand on the lowest rung or otherwise anchor the
base of the ladder to prevent slipping. When viewed from the front, the top of the ladder section(s) must always be directly above
the base.
9Place ladder at an angle of 65° to 70° - foot of ladder 1 metre from wall for each 3 metres up for stability.
9 Wherepossible,lashtopofladdertoaxturetopreventslipping.
WARNING!Neverover-reachwhenontheladderstand-o󰀨.
9Keep children and unauthorised persons away from the working area.
8DO NOTusetheladderstand-o󰀨foranypurposeotherthanthatforwhichitisdesigned.
8DO NOT use the equipment if any parts are damaged or missing as this may cause failure and/or personal injury.
8DO NOT allow children to climb the ladder.
8DO NOTusetheequipmentwhenyouaretiredorundertheinfluenceofalcohol,drugsorintoxicatingmedication.
2. INTRODUCTION
Aluminiumframedstand-o󰀨,tstoanyladder.O󰀨erssuperbstabilityatthetopofaladderwithawidespanof1000mm.Positionsladder
360mm away from work area. Fitted with rubber feet to help prevent slipping. Supplied with easy installation instructions.
3. SPECIFICATION
Model No.: ................................................................LAD002
Span Width: .............................................................1000mm
StandO󰀨:...................................................................360mm
4. CONTENTS
4.1. CONTENTS
LAD002 Issue 2 03/11/21
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Item Qty.
U Bolts 2
Wing Nuts 4
Washers 9
Bolts 5
Nylock Nuts 5
Paint Can Hook 1
Support Bar 1
Stand-Off Bar 1
Ribbed Plate 1
g.1

5. ASSEMBLY
5.1. STAND-OFF ASSEMBLY
5.1.1. Assemblethestand-o󰀨asFig.1.Bolttheribbedplateontothemainframe
make sure that the ribbed side is facing outwards, secure with bolt,
washer and nuts (Fig.1a).
5.1.2. Attach the support bar to the main frame using a bolt washer and nut,
choose which side you wish to have the paint hook and include that
between the frame and washer (Fig.1b).
5.2. ATTACH THE STAND-OFF TO THE LADDER
5.2.1. Thestand-o󰀨issecuredtotheladderwiththetwoUbolts,washersand
 thumbscrews(Fig.1c,Fig.2).Ensurethattheangledribbedplateisush
with the angle of the ladder.
Original Language Version
© Jack Sealey Limited
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 [e-mail] www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior
notice.
Important: No Liability is accepted for incorrect use of this product.
Warranty: Guarantee is 12 months from purchase date, proof of which is required for any claim.
g.2
LAD002 Issue 2 03/11/21