Sealey Led318r User manual

5W COB & 3W SMD LED RECHARGEABLE

INSPECTION LIGHT WITH POWER BANK

MODEL NO: LED318 SERIES

Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions,

and properly maintained, give you years of trouble free performance.

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE

THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR

PERSONAL INJURYAND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.

1. SAFETY

1.1. GENERAL SAFETY

9Ensure the light is fully charged before initial use.

8DO NOT turn the light on when it is being charged.

8DO NOT shine directly into your, another person’s or an animal’s eyes.

8DO NOT allow children to use the light.

8DO NOT handle or move the light whilst it is being charged.

8DO NOT use the light if you suspect that the battery or the light casing is damaged.

8DO NOT leave battery in a discharged state, recharge battery immediately. Before storage, fully recharge the battery, subsequently

recharge the battery at least once every six months of non-use.

1.2. BATTERY SAFETY

WARNING! To reduce the risk of burns or re:

8DO NOT attempt to open, disassemble, modify or service the battery pack.

8DO NOT crush, puncture, short external contacts or dispose of in re or water.

8DO NOT expose to temperatures above 60°C (140°F).

9Recycle or dispose of used battery as stipulated by local regulation.

9If the electrolyte in the cells gets on your skin, thoroughly wash with soap and water. If it gets in

your eyes, rinse thoroughly with cool water and seek immediate medical attention.

2. i INTRODUCTION

Featuring a super bright 5W COB LED light source, which gives an even and constant spread of

light, producing up to 400 lumens. 3W High power SMD LED torch producing up to 100 lumens.

Integral hanging hook/belt clip with magnets and a magnetic base which can rotate through 180°

for hands-free applications. Features a battery level indicator. Rechargeable 3.7V 2Ah lithium-

ion battery for longer life, no memory effect and a much slower discharge than traditional Ni-MH

batteries. Built-in emergency power bank to charge mobile devices. Supplied with Micro USB

cable.

3. i SPECIFICATION

MModel No:odel No:..........................................................................LED318G / LED318RLED318G / LED318R

BBattery:attery: ....................................................................................3.7V 2Ah Lithium-ion3.7V 2Ah Lithium-ion

CCharging Time:harging Time:......................................................................................................................3hr3hr

IInput Voltage:nput Voltage:.............................................................................................................. 5V~1A5V~1A

LLED Type:ED Type:..............................................................................5W COB + 3W SMD5W COB + 3W SMD

LLength:ength:................................................................................................................................190mm190mm

LLumen Output:umen Output:........................................................Side - 400/Top - 100lmSide - 400/Top - 100lm

OOperating Time:perating Time: ......................................................................Side - 3/Top - 5hrSide - 3/Top - 5hr

OOutput:utput:.................................................................................................................................. 5V~1A5V~1A

IMPORTANT WARRANTY INFORMATION

The battery tted to this light is considered to be a consumable item and its ability to accept a charge will reduce over time. We will

provide warranty against mechanical and electrical defect for a period of one year - this DOES NOT cover fair wear and tear. If the

battery is not properly charged before rst use, or regularly conditioned, its capacity will diminish. Under these circumstances we will

not replace the battery regardless of whether it is less than one year old.

4. OPERATION

4.1. CHARGING

4.1.1. Connect the USB lead to the input socket on the side of the light (g.1).

NOTE: there is also an output socket (g.3), which is used for charging mobile devices.

4.1.2. Plug USB lead into a power supply and turn on.

4.1.3. When the battery has fully charged the 5 GREEN LEDs on the rear will illuminate.

Refer to

instruction

manual

LED318

SERIES

Original Language Version

4.1.4. Each LED represents 20% of the charge level.

4.2. OPERATION

4.2.1. Direct the lens away from your eyes before switching on.

4.2.2. Toggle the light between the end light and side light using the centre On/O󰀨 button (g.2).

4.2.3. The (+) brighter and (-) dimmer buttons will only operate on the ood (side) light, (g.2).

4.2.4. The light may be suspended by the hook or attached to any ferrous surface by using the magnets. Angle the light to suit (g.3).

4.2.5. Use the Output port to charge mobile devices (g.3).

5. MAINTENANCE

5.1. Keep the torch clean by wiping with a damp cloth.

5.2. Store torch in a dry childproof area.

Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR

01284 757500 sales@sealey.co.uk www.sealey.co.uk

ENVIRONMENT PROTECTION

Recycle unwanted materials instead of disposing of them as waste.All tools, accessories and packaging should be sorted,

taken to a recycling centre and disposed of in a manner which is compatible with the environment. When the product

becomes completely unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and

dispose of the product and fluids according to local regulations.

Note: It is our policy to continually improve products and as such we reserve the right to alter data, specifications and component parts without prior

notice.

Important: No Liability is accepted for incorrect use of this product.