
9Ensure these dust extraction and collection facilities are connected and properly used. Use of dust collection can reduce dust-
related hazards.
9Disconnect the saw from the battery unit before changing accessories, servicing or performing any maintenance.
9Maintain the saw and battery in good condition. Check moving parts alignment on a regular basis.
9Replace or repair damaged parts. Use an authorised service agent and recommended parts only. Unauthorised parts may be
dangerous and will invalidate the warranty.
9 Ensure the saw is switched o before installing the battery pack.
9Keep the saw and charger clean for best and safest performance.
9 Evaluate your working area before using the multi-tool e.g. ceilings, oors and enclosures may contain electrical items or water
piping.
9Ensure battery pack is correctly inserted into the tool handle and latched in place before attempting to switch it on.
9Secure loose work pieces with a clamp, vice or other adequate holding device.
9Wear approved safety eye protection (standard spectacles are not adequate).
9 Maintain correct balance and footing. Ensure the oor is not slippery and wear non-skid shoes.
9Keep children and unauthorised persons away from the working area.
9Keep tool and charger in the case and store in a safe, dry, childproof area where the temperature will not exceed 104°F (40°C).
8DO NOT use the tool where there are ammable liquids, solids or gases, such as paint solvents, etc.
8DO NOT allow children to operate the tool.
8DO NOT operate the tool if any parts are missing as this may cause failure and/or personal injury.
8DO NOT hold unsecured work piece in your hand.
8DO NOT leave the tool operating unattended.
8DO NOT use the tool for a task it is not designed to perform.
8DO NOT operate the tool when you are tired or under the inuence of alcohol, drugs or intoxicating medication.
8DO NOT get the tool or battery charger wet or use in damp or wet locations.
1.4. POWER TOOL USE AND CARE
8DO NOT force the power tool. Use the correct power tool for your application. The correct power tool will do the job better and
safer at the rate for which it was designed.
8DO NOT use the power tool if the switch does not turn it on and o. Any power tool that cannot be controlled with the switch is
dangerous and must be repaired.
9Disconnect the plug from the battery pack from the power tool before making any adjustments, changing accessories, or storing
power tools. Such preventive safety measures reduce the risk of starting the power tool accidentally.
9Store idle power tools out of the reach of children.
8DO NOT allow persons unfamiliar with the power tool or these instructions to operate the power tool. Power tools are dangerous in
the hands of untrained users.
9 Maintain power tools. Check for misalignment or binding of moving parts, breakage of parts and any other condition that may aect
the power tool’s operation. If damaged, have the power tool repaired before use.
9Keep cutting tools sharp and clean. Properly maintained cutting tools with sharp cutting edges are less likely to bind and are easier
to control.
9Use the power tool, accessories and tool bits etc. in accordance with these instructions, taking into account the working conditions
and the work to be performed.
9 Use of the power tool for operations dierent from those intended could result in a hazardous situation.
2. INTRODUCTION
Powerful, lightweight cordless Jigsaw suitable for cutting wood, board, plastic and steel. Comfortable composite housing with soft grip for
added comfort. Tool-free blade change system. Variable speed control trigger switch 0-2400spm. Features dust blow and extraction function,
and parallel guide. Built-in LED work light. Four pendulum settings. Two stage operation switch for added safety. Supplied with hex key and
wood cutting blade. Requires Model No’s CP20VBP, CP20VBP2 or CP20VBP4 20V Battery and Model No. CP20VMC Mains Charger.
3. SPECIFICATION
Model No:........................................................................................................................................................CP20VJS
Battery: .................................................................................................................... 20V 2Ah - 4Ah Li-ion (not included)
No Load Speed: .............................................................................................................................................0-2400spm
Stroke Length:........................................................................................................................................................25mm
Wood: ....................................................................................................................................................................80mm
Plastic: ...................................................................................................................................................................12mm
Steel:......................................................................................................................................................................10mm
Metal Pipe:.......................................................................................................................................................Ø5-25mm
Noise power:......................................................................................................................................................... 90dbA
Noise pressure:..................................................................................................................................................... 79dbA
Consumable Parts (NOT INCLUDED):
CP20VBP2....................................................................................................................................................2Ah Battery
CP20VBP......................................................................................................................................................3Ah Battery
CP20VBP4....................................................................................................................................................4Ah Battery
CP20VJS Issue 1 25/09/19
Original Language Version
© Jack Sealey Limited