Sealey APICCOMBO1 User manual

IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE THE PRODUCT
CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR PERSONAL INJURY AND WILL
INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these instructions
and maintained properly, give you years of trouble free performance.
Refer to instruction
manual
APICCOMBO1 Issue:1 - 23/10/17
Original Language Version
© Jack Sealey Limited
INSTRUCTIONS FOR:
INDUSTRIAL MOBILE STORAGE SYSTEM WITH
SHELF
MODEL NO: APICCOMBO1
1. SAFETY
1.1. GENERAL SAFETY
WARNING! Ensure Health & Safety, local authority, and general workshop practice regulations are adhered to when using this unit.
9Always load evenly with the centre of gravity of the load as near the centre as possible.
9Use the trolley in a suitable work area.
9Keep the work area clean, uncluttered and ensure there is adequate lighting.
9Keep the trolley clean and tidy in accordance with good workshop practice.
8DO NOT use the trolley for any purpose other than that for which it is designed.
8DO NOT stand on the trolley, use it as a ladder or allow others to ride on the trolley.
9Use the wheel locks to prevent the trolley from inadvertently moving.
8DO NOT leave unattended, especially when loaded, unless the wheels are locked, chocked or the trolley otherwise secured.
8DO NOT use trolley on uneven ground and do not run over curbs or steps - use a ramp.
8DO NOT use trolley if any part is significantly damaged, paying particular attention to the wheels.
9Keep children and unauthorised persons away from the work area.
2. INTRODUCTION
Industrial quality mobile storage system for use in the garage or workshop environment. Supplied with six panels; three louvred panels, to accept
storage bins, and three perforated panels which can be used with Sealey TTS clips for tool storage. These can be mounted in any configuration,
allowing the user to customise the design to suit their needs. It also includes a single shelf, which can be mounted at various heights. Four heavy-
duty castors, of which two are fitted with toe locks, give smooth manoeuvrability around the workplace.
3. SPECIFICATION
Model No: ................................. APICCOMBO1
Overall Size (W x D x H): ................ 960 x 640 x 1605mm
Perforated Panel Size (x3) (W x H): ............. 925 x 1350mm
Louvred Panel Size (x3) (W x H): ............... 925 x 1350mm
Weight:.............................................60kg

4. ASSEMBLY
g.1
g.1 g.2
g.3
4.1. Assemble the framework as in fig.1.
4.2. The punched and louvred panels can be
attached to the uprights in any required
order (fig.2).
4.3. The shelf should be attached to the end
plates (fig.3) and hung at the required level.
Sealey Group, Kempson Way, Suffolk Business Park, Bury St Edmunds, Suffolk. IP32 7AR
01284 757500 01284 703534 [e-mail] www.sealey.co.uk
ENVIRONMENT PROTECTION
Recycle unwanted materials instead of disposing of them as waste. All tools, accessories and packaging should be sorted, taken to
a recycling centre and disposed of in a manner which is compatible with the environment. When the product becomes completely
unserviceable and requires disposal, drain any fluids (if applicable) into approved containers and dispose of the product and fluids
according to local regulations.
APICCOMBO1 Issue:1 - 23/10/17
Original Language Version
© Jack Sealey Limited