
INSTRUCTIONS FOR
WATER PUMP REMOVAL KIT VW
MODEL NO: VSE6000
Thank you for purchasing a Sealey product. Manufactured to a high standard, this product will, if used according to these
instructions, and properly maintained, give you years of trouble free performance.
IMPORTANT: PLEASE READ THESE INSTRUCTIONS CAREFULLY. NOTE THE SAFE OPERATIONAL REQUIREMENTS, WARNINGS & CAUTIONS. USE
THE PRODUCT CORRECTLY AND WITH CARE FOR THE PURPOSE FOR WHICH IT IS INTENDED. FAILURE TO DO SO MAY CAUSE DAMAGE AND/OR
PERSONAL INJURY AND WILL INVALIDATE THE WARRANTY. KEEP THESE INSTRUCTIONS SAFE FOR FUTURE USE.
1. SAFETY
WARNING! Wear approved eye protection. Wear appropriate Personal Protective Equipment. A full range of Personal Protective
Equipment is available from your Sealey dealer.
WARNING! Ensure that Health & Safety, Local Authority Regulations and general workshop practice Regulations are adhered to when
using tools.
8DO NOT use tools if damaged.
9Maintain tools to ensure that they are in an adequate condition for safe use and optimum performance.
9Ensure that a vehicle that has been raised by a jack is adequately supported. Use axle stands.
9Wear suitable clothing to avoid snagging. DO NOT wear jewellery. Tie back long hair.
9Account for all tools, parts and components being used. DO NOT leave these in or near the engine. Return tools to suitable storage
after use.
These Instructions are provided as a guide only. Always refer to the vehicle manufactures’ service instructions or a proprietary
manual to establish the correct procedure and data.
WARNING! The warnings, cautions and instructions in this manual cannot cover all possible conditions and situations. The Operator /
user must apply caution and common sense (good practical sense).
WARNING! Incorrect or out of phase camshaft timing can result in contact between the valve head and the piston crown. This will cause
damage to the engine.
2. INTRODUCTION
Suitable for removing the water pump on Pumpe Duse, diesel, gear drive engines. Essential to align the engine in the TDC position. Supplied
in a storage case.
3. CONTENTS
Item: Part No: Description: OEM No:
1 VSE6000.01 Camshaft TDC Tool T10225
2 VSE6000.02 Gear puller T10221A
3 VSE6000.03 Water Pump Puller T10221A
4 VSE6000.04 Socket Cap Screw _
VSE6000.V2 | Issue 1 27/01/17
Original Language Version
© Jack Sealey Limited
Refer to
instructions
Wear eye
protection
Wear protective
gloves
Wear safety
footwear
Wear protective
clothing