Seconique Corona User manual

ASSEMBLY INSTRUCTIONS
floor and the product.
• We strongly recommend that you keep children away from your work area.
• Assemble this product as close to its final position as possible.
• Never drag or push products as this could cause damage to the joints making it inferior.
• Do not place this product next to a radiator or in direct sunlight.
• Wood is a natural product and may expand if subjected to damp and may shrink or crack
if subjected to heat. Therefore it is recommended that room temperature is maintained,
with no sudden temperature fluctuations.
• Make sure any spillage is wiped off immediately.
• Do not place hot or chilled items directly on to the surface, use a place mat or marking
will occur.
• For general cleaning use a duster, and do not use detergents of any kind. However, the
surface will need to be retreated from time to time. This can be done by using block wax
(unperfumed) and rubbing it over the whole item.
• From time to time it may be necessary to tighten fittings, regular inspections should be
carried out.
PAGE 1
CORONA ' TABLE6
After unpacking this product please keep the original packaging in case it needs to be
returned for any reason.
• Please ensure all fittings and parts are present before commencing with assembly.
• We recommend that you lay a blanket or sheet on the floor to avoid damage to both your
CARE AND MAINTENANCE
IMPORTANT
PLEASE READ BEFORE YOU CONTINUE FURTHER
SEC/WG/0 / /KK13 18
FOR DOMESTIC USE ONLY

14
08
D
C
PAGE 2
FITTINGS
PARTS LIST
part
number
name of
part quantity
1Table Top
Table Leg ( marking)blue
1
2 2
3
Table Leg (yellow marking)
Short frame side
2
4 2
part
number
name of
part quantity
5
Long frame side
2
part
number
name of
part quantity
4,0 x 40
* Use of power tools to assemble this product will invalidate
any claim and could damage this product making it unsafe!!!
* Please assemble on a clean soft surface to avoid damage.
* Please check contents and read the instructions before commencing assembly.
* Assemble this product following the enclosed instructions carefully.
* Please take care to avoid damaging parts during assembly.
2,5m x 3m
08
01
B
A
Ø1/4" x 120
4
3
5
2
2
4
3
5
1
10 x 40
08
E
1/4"
GLUE
01
F
SEC/WG/0 / /KK13 18

YELLOW
01
5
3
2
5
D
D
4
D
D
02
x2
A
A
E
E
BLUE
YELLOW
ADD GLUE
ADD GLUE
x2
x2
Glue must be added
to Parts 4 and 5.
Glue must be added
to Parts 2,3 and 5.
PAGE 3
D 08
F 01
10 4x 0mm
A
E
04
04
B 01
F 01
Ø1/4" x 120
1/4"
SEC/WG/0 / /KK13 18

4
4
03
04
E
E
E
E
A
A
A
A
ADD GLUE
FOR YOUR FUTURE
REFERENCE
ORDER NUMBER
SHOULD BE HERE
SPD XXXXX
CENTRALIZE
C
C
CC
C
C
C
C
C
CC
C
C
Glue must be added
to Parts 2,3 and 4.
C
C
PAGE 4
A
E
04
04
B 01
F 01
Ø1/4" x 120
1/4"
C 12
4,0 x 40
SEC/WG/0 / /KK13 18

ASSEMBLY INSTRUCTIONS
IMPORTANT
PLEASE READ BEFORE YOU CONTINUE FURTHER
After unpacking this product please keep the original packaging in case it needs to be
returned for any reason.
• Please ensure all fittings and parts are present before commencing with assembly.
• We recommend that you lay a blanket or sheet on the floor to avoid damage to both your
floor and the product.
• We strongly recommend that you keep children away from your work area.
• Assemble this product as close to its final position as possible.
• Never drag or push products as this could cause damage to the joints making it inferior.
• Do not place this product next to a radiator or in direct sunlight.
• Wood is a natural product and may expand if subjected to damp and may shrink or crack
if subjected to heat. Therefore it is recommended that room temperature is maintained,
with no sudden temperature fluctuations.
• Make sure any spillage is wiped off immediately.
• Do not place hot or chilled items directly on to the surface, use a place mat or marking
will occur.
• For general cleaning use a duster, and do not use detergents of any kind. However, the
surface will need to be retreated from time to time. This can be done by using block wax
(unperfumed) and rubbing it over the whole item.
• From time to time it may be necessary to tighten fittings, regular inspections should be
carried out.
CARE AND MAINTENANCE
PAGE 1
CORONA CHAIR
FOR DOMESTIC USE ONLY
SEC/AY/02/18/KK1

BD
AC
PAGE 2
FITTINGS
PARTS REQUIRED PER CHAIR
part
number
name of
part quantity
1
Right Chair Side
Left Chair Side 1
2 1
3Chair Seat
Back Rail
1
4 3
part
number
name of
part quantity
5
Front Seat Rail
1
6
Back Seat Rail
1
part
number
name of
part quantity
08
12
04
8,0 x 30
16
4,0 x 35
E
F
* Use of power tools to assemble this product will invalidate
any claim and could damage this product making it unsafe!!!
* Please assemble on a clean soft surface to avoid damage.
* Please check contents and read the instructions before commencing assembly.
* Assemble this product following the enclosed instructions carefully.
* Please take care to avoid damaging parts during assembly.
2,5m x 3m
01
02
05
06
04 03
Ø 7 x 60
GLUE
01
02
Ø 7 x 90
(BIGGER)
(SMALLER)
04
04
FOR YOUR FUTURE
REFERENCE
ORDER NUMBER
SHOULD BE HERE
SEC/AY/02/18/KK1

01
E
C
C
PAGE 3
04 x3
C
Glue must be added to
the dowel holes on
parts 1,2 and 4.
C
01
05
06
04
B
B
A
B
B
A
F
02
B
F
04
04
SEC/AY/02/18/KK1
C 06
E 01
8x30mm
A
F
01
01
7,0 x 90
B 04
7,0 x 60

PAGE 4
03
02
05
06
04
B
B
B
B
A
A
F
04
04
04
3
D
D
D
D
CENTRALIZE
D
A
F
01
01
7,0 x 90
B 04
7,0 x 60
D 04
4,0 x 35
SEC/AY/02/18/KK1