Mocka Sintra User manual

Sintra Console Table
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
1
Hardware Supplied
For quicker assembly, we recommend the
use of a power drill on a low-speed setting.
Phillips screwdrivers and hammer required
A B CD
dowel
x8
E
plastic
glide x6 x8 x8
Thank you for your purchase. Please follow the instructions for correct assembly.
While we took great effort to ensure these assembly instructions were correct at
the time of printing, sometimes updates are required post production. For the
most up to date versions please refer to the product page on our website.
mocka.com.au/mocka.co.nz
F
x1x8
threaded
rods
half round
Nuts
spanner
G
x6
screwhexagonal
nuts
H
x8
sticker
Wall Strap
x2
washer
Z
Y
wall
anchor
x1
X
safety
strap x1
WV
screw
x1
wall
screw
x1

Sintra Console Table
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
2
Panel layout
1
Attach 8x threaded rods (C) to panel [1] and hand tighten by turning clockwise.
C
CCC
CCC
C
1
1
3
5
2
4

Sintra Console Table
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
3
23
Attach panel [3] to panel [2] with 2x dowels (A) and secure with
3x screws (G). Tighten with a screwdriver. Attach panel [5] to
panel [4] with 2x dowels (A) and secure with 3x screws (G).
Tighten with a screwdriver.
Attach panels [2], [3], [4] and [5] to panel [1] with 4x dowels (A) and
using 8x half round nuts (D) and 8x hexagonal nuts (E). Tightening
with spanner (F).
A
G
G
G
G
G
G
A
A
A
AA
F
E
D
2
23
5
5
3
1
4
4
G
A
A

Sintra Console Table
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
4
54
Attach 6x plastic glides (B) to the panels [2], [3], [4] and [5] using a
hammer. Apply 8x stickers (H) to the panel [2], [3], [4] and [5] as
shown.
H
H
H
BB
B
B
B
B
B
2
5
3
4
V
Z
W
V
Z
W
Attach 1x safety straps (V) to the top of the back side of the unit as shown
using 1x washer (Z) and 1x screws (W). Tighten with a screwdriver.

X
Y
Z
wall
anchor
screw
strap
washer
Sintra Console Table
Assembly Instructions
mocka.co.nz | mocka.com.au | PO BOX 6171, Maroochydore, QLD, 4558
5
76
You’re done, enjoy!
Once assembled lift furniture into place, do not drag. Use a drill to
create a small hole lining up with the top of the safety strap (V).
Fasten to the wall using 1x washer (Z), 1x wall anchor (X) and
1x screw (Y). Ensure unit is balanced and steady before use.
You’re done, enjoy!