Sekonic Flashmate L-308S User manual

L-308S Quick Guide
MEASURING
BUTTON
UP BUTTON
DOWN BUTTON
ISO BUTTON
·PRESS ISO BUTTON DOWN WHILE USING
UP/DOWN BUTTONS TO SELECT ISO.
·IN AMBIENT MODE , TO CHANGE
BETWEEN F-STOP AND EV MEASUREMENTS,
HOLD DOWN THE ISO BUTTON AND PRESS
THE MODE BUTTON.
FLASH SYNCHRO TERMINAL
WHEN CORD IS ATTACHED PUSH
MEASURE BUTTON TO TRIGGER
FLASH AND MEASURE LIGHT
LUMISPHERE
MODE BUTTON
FLASH
FLASH W/CORD
DAYLIGHT
DAYLIGHT
M O D E
POWER
ISO
POWER BUTTON
(ON/OFF SWITCH)
LCD SCREEN
Shutter Speed,
f.p.s. Display Aperture Value,
EV Display
ISO DisplayMeasuring Mode
Battery Indicator

L-308S Basic Operation
Set ISO
While holding down ISO button, press the Up/Down buttons.
Use as Reflected Meter
Slide Lumisphere away to expose meter cell.
Use as Incident Meter
Slide Lumisphere over meter cell.
Measure Brightness /Contrast Difference
Clip in flat Lumidisc over meter cell.
Ambient Reading
Select Ambient Mode, press Measuring button.
Cordless Flash Reading
Select Cordless Flash Mode, press Measuring button
to manually trigger the flash.
Flash Reading Using Flash Cord
Select Flash with Cord Mode, connect flash synchro cord
into PC socket and press the Measuring button.
EV Reading
Select Ambient EV Mode. In Ambient Mode, change
between F/Stop and EV readout by holding down ISO button
and pressing Mode button.
To Set Increments of Reading
1.Turn power off.
2.Press down Mode button while turning on meter.
3.Press Mode button to select Full, 1/2 or 1/3 f-stop increment
reading.
4.Turn power off and then back on to activate functions.