SelectBlinds Cordless Honeycomb Shades User manual

Installation Guide
Cordless Honeycomb Shades
P1
Locating the brackets
5cm 5cm
The position that you place the outermost brackets must be
5cm away from the end of the rail. Any additional brackets
(supplied for wider blinds) can then be evenly distributed
across the window space. Use a pencil to mark the window
area where the brackets will be positioned.
Ensure that the back of the
bracket sits clear of any
protruding items such as
window handles or vents. This
will allow the blind to hang
correctly once installed.
The brackets offer two methods of installation:
Top-Fixing
Use the single hole in the top of the bracket to fix to
the lintel (the ‘ceiling’ of the recess).
Face-Fixing
Use two screws through the back plate to mount
onto a facing surface (a wall or window frame)
Situate the front lip of the
headrail into the front
hook of the bracket.
Push the back of the
headrail upwards to
engage the metal clip at
the back of the bracket.
Fitting the brackets
Fitting
the blind

Installation Guide
Cordless Honeycomb Shades
P2
If the blind appears too short when fitted, don’t worry, it can take some time for the pleats
to settle and loosen up when the blind is new. Leave the blind lowered for 24 hours and
you should find that it begins to settle quite quickly. If you want to help it along, you can
simply pull the blind down to its fullest extent and brush your hand vigorously down the
pleats from top to bottom. Do not attempt to adjust the cords.
Cleaning the blind is easy; keep it free of dust using the brush attachment of a vacuum
cleaner, and clean any marks or stains using a damp cloth or sponge. Do not soak the
blind fabric as this can cause the pleats to lose their shape.
To remove the blind from the brackets, insert a flat head screwdriver into the tab protruding
from the bottom of the rail, then gently pry it back while tilting the back of the rail down-
wards. Repeat this carefully for each bracket to release the rail.
On shades up to 48” wide, center the handle in the
middle of the shade's bottom rail. For wider shades,
space handles no more than 40” apart. To attach
handles, mark their position on the bottom rail lightly
with a pencil. Gently press the front of the handle
onto the front edge of the rail and at the same time,
press the bottom of the handle onto the underside of
the rail until you hear it click into place.
Additional
Information