Sennheiser Audiology SET 810 Infra-red Operator's manual

Sennheiser electronic GmbH & Co. KG Phone [phone] Printed in Germany
30900 Wedemark, Germany Fax [phone] Publ. 04/07
www.sennheiser.com xxxxxx / A01
A
B
C











Set 810
Connecting the system components
 Plug in one end of the connecting cable  to the socket on your sound source (e.g. television) .
If necessary, use one of the adapters , (not included)or . Plug in the other end of the connec-
ting cable  to the socket LINE  on the transmitter .
 Connect the mains unit to the transmitter and to the mains.
 Place the receiver into the transmitter’s charging compartment .
 Before you use the rechargeable battery  for the first time, charge it until the LED lights up green.
 Adjust the volume on your sound source(TV Set) to a sufficient, medium level.
Switching on and using the stethoset receiver
 The receiver automatically switches on when you pull the earbows apart.
First adjust the volume to a low level. This protects your hearing from damage.
Then put the receiver on and adjust the volume to a comfortable level.
 If you cannot hear anything through the receiver, increase the volume on your sound
source.
Switching the stethoset receiver off
 The receiver automatically switches off when you take it off.
Charging the stethoset reciever
 Place the receiver into the transmitter’s charging compartment  without exerting too much
pressure. With a fully charged battery, the operating time is approx. 4 hours.
For details on the use of the Set 810, please refer to the enclosed operating instructions.
Quick instructions