Seville Classics FRN04745 User manual

Step 2: Refer to the diagram below. First, tighten the 9 pre-inserted screws (marked
“A” in the picture). Next, screw in and tighten the 6 short screws into the 6 screw holes
on the unit (these screw holes are marked “B” in the picture). Do NOT over tighten the
screws.
Step 3: Use a Phillips screwdriver to screw in and tighten a Bracket (C) using 2
Bracket Screws (D) at four corners of the unit.
How to Fold the Bookcase (If Needed): First, fully loosen and remove all 4 brackets
(marked “C” in the picture above) from the unit. Then, fully loosen and remove all 6
short screws (marked “B” in the picture above) from the unit. Next, fully loosen (about
5 turns), but do NOT remove, the 9 remaining pre-inserted screws (marked “A” in the
picture above). Finally, carefully fold down the unit. Please note that the unit
CANNOT be folded completely flat. Forcing the unit into a folded position without first
removing the 4 brackets, 6 short screws and fully loosening the 9 pre-inserted screws
may result in irreparable damage to the unit.
4
Resin 3-Tier Book Case
Model No. FRN04745
ASSEMBLY INSTRUCTIONS
CustomerService
Tel [phone]
Fax [phone]
Monday through Friday 8:30AM-4:30PM (PST)
Seville Classics, Inc.
Torrance, CA 90501 USA
www.sevilleclassics.com
1

READANDSAVETHESEINSTRUCTIONS
CAUTION
1) Do NOT overly tighten the screws. Doing so may damage the unit.
2) Do NOT place the unit in high temperature area or near appliances that emit large
amount of heat.
3) Do NOT place the unit in direct sunlight as it may cause the color to fade.
4) Do NOT place the unit on uneven surfaces. Doing so may cause the unit to tip over.
5) Examine the screws periodically and tighten them if they are loose.
6) Weight capacity: 75 lb per shelf
7) Check unit to ensure that it is level before use.
PARTS LIST
Please check all the parts you received according to the parts list below.
(A) (B)
Folded Bookcase (1 pc) (A) Long Screw (9 pcs)
pre-inserted in the unit
(B) Short Screw (6 pcs)
(C) (D)
Bracket (4 pcs) Bracket Screw (8 pcs)
*Tools needed: Phillips Screwdriver and Level
2
Please Note:
1) Do NOT place the unit vertically when unfolding as this may result in the unit
suddenly unfolding and pinching your fingers.
2) Find a flat surface or floor to assemble the unit. Using an uneven surface or floor to
assemble the unit may result in uneven/unlevel shelves, which can compromise the
strength of the unit.
3) Check unit before using to ensure it is level.
4) If the unit is uneven/unlevel after assembled, loosen both screws (A and B), adjust
the unit and then retighten the screw (A and B).
ASSEMBLY INSTRUCTIONS
Step 1: Use a Phillips screwdriver to loosen the 9 long screws (A) that have already
been pre-inserted in the unit. Do NOT remove the screws from the unit. Simply
loosen them to allow the unit to unfold. Next, place the compressed unit horizontally
and position your hands to carefully unfold the unit.
3