Seville Classics UltraHD 20164 User manual

TR170308
ASSEMBLY INSTRUCTIONS
UltraHD Storage Cabinet (Model No. 20164)
24in. W X 18in. D X 66in. H
(60.96cm x 45.72cm x 1.68 m)
Reference page 12 for special care
and maintenance of stainless steel

(pg 1 of 13)

(#6-A) Door
(pg 2 of 13)
(#1-A) Left Panel
(#2-A) Right Panel

(#5) Middle Shelf x 2PC
(#7) Middle Layer Panel x 1PC
(#2-A2) Right Side - Bottom Panel x 1PC
(#1-A2) Left Side - Bottom Panel x 1PC
PARTS LIST (pg 3 of 13)
Please check the parts carefully according to the parts list. If you are missing any parts, please contact our customer
service department. (please refer to page 13 of 13) .
(#1-A1) Left Side - Upper Panel x 1PC
(#2-A1) Right Side - Upper Panel x 1PC
(#3) Top Panel x 1PC
(#4) Bottom Panel x 1PC

(#8) Upper Back Panel x 1PC
(#9) Middle Back Panel X 2PCS
(#6-A3) Door Panel Connection Part x 1 PC
(#10) Bottom Back Panel x 1PC
(#6-A2) Door - Bottom Panel x 1PC
(#6) Leveling Feet x 4 PCS
PARTS LIST (pg 4 of 13)
Please check the parts carefully according to the parts list. If you are missing any parts, please contact our customer
service department. (please refer to page 13 of 13) .
(#6-A1) Door - Upper Panel x 1PC
(#6-A4) Key Rod x 1 PC

(#21) Screw Driver x 1 PC
（#23-B）Magnet - B x 1PC
(#54) Screw N (M4 x 10L) x 24 PCS
PARTS LIST (pg 5 of 13)
Please check the parts carefully according to the parts list. If you are missing any parts, please contact our customer
service department. (please refer to page 13 of 13) .
(#17) Middle Corner Protection x 6 PCS
(#22) Key x 2 PCS
(#23) Magnet x 2 PCS
(#25) Wrench x 1 PC
(#34) Hook x 8 PCS

(#53) Screw L (M4 x 6L) x 1 PC
(#41) Screw F (M4 x 8L) x 65 PCS
PARTS LIST (pg 6 of 13)
Please check the parts carefully according to the parts list. If you are missing any parts, please contact our customer
service department. (please refer to page 13 of 13) .
(#27-B) Washer (M8)x 2 PCS
(#27) Washer (M4) x 2 PCS
(#42) Screw G (M4 x 30L) x 12 PCS
(#52) Screw K (M4 x 10L) x 4 PCS
(#55) Screw M (M6 x 50L) x 2 PCS
(#55-A) Wall Anchor x 2 PCS
M8X20 pcs

PARTS LIST (pg 7 of 13)
Please check the parts carefully according to the parts list. If you are missing any parts, please contact our customer
service department. (please refer to page 13 of 13) .
(#61) Screw O (M4 x 12L) x 2 PCS
(#60) Mounting Strap x 2 PCS

TIP:
WARNING:
Step 1: Install Left Side Panel (#1-A)
Step 2: Install Right Side Panel (#2-A)
Step 3: Install Door Panel (#6-A)
Note:
Make sure all the panels assembled up to this point are
flush.
ASSEMBLY INSTRUCTIONS (pg 8 of 13)
UltraHD Storage Cabinet (Model No. 20164)
Some parts may have sharp edges. To avoid injury,
wearing gloves is recommended during assembly.
A magnetic screwdriver is included for your
convenience. If a power screwdriver is used, keep
on a low torque setting.
Place the Left Side - Upper Panel (#1-A1) and Left Side
- Bottom Panel (#1-A2) together, line up screw holes,
use 3pcs of Screw G (#42) to tighten from the side
Repeat Step 1, place Right Side Upper Panel (#2-A1),
Right Side Bottom Panel (#2-A2) together, line up
screw holes, use 3pcs of Screw G (#42) to tighten from
the side
1). Place Door - Upper Panel (#6-A1) and Door -
Bottom Panel (#6-A2) together, line up screw holes,
use 2 pcs Screw F (#41) to tighten from the side.
2). Place the Door Panel Connection Part (#6-A3) over
the touching sides, line up the screw holes, use 4pcs
Screw F (#41) to tighten from the top, and use 4pcs
Screw K (#52) to tighten from outside edge.

Step 4: Install Key Rod (#6-A4)
Step 5: Install Top Panel (#3) to Left Side Panel (#1-A)
and Right Side Panel (#2-A)
Note:
Step 6: Install Bottom Panel (#4) to Left Side Panel (#1-A)
and Right Side Panel (#2-A)
Note:
Step 7:
Install Middle Layer Panel（#7）
Note:
Before tightening screws, make sure the corners of the
Bottom Panel (#4) are completely flush.
Attached the Middle Layer Panel (#7) as the left picture
shows. Use 8 pcs of Screw F (#41) to fasten the Middle
Layer Panel to the Left and Right Panel (#1 and #2).
Before tightening screws, make sure the front of the
panel faces downward.
Attach Bottom Panel (#4) to Left Side Panel (#1-A) and
Right Side Panel (#2-A). Make sure the front of the unit
faces downward. Line up screw holes, use 6pcs Screw G
(#42) to tighten.
ASSEMBLY INSTRUCTIONS (pg 9 of 13)
UltraHD Storage Cabinet (Model No. 20164)
Insert Key Rod (#6-A4) into the bottom tab hole of the
Door - Bottom Panel (#6-A2), twist out the Pre-
assembled Screw L (#53) on the key rod linkage plate,
attach Key Rod (#6-A4) by lining up the screw hole and
tightening back in the Screw L (#53)
Before tightening screws, make sure the corners of the
Top Panel (#3) are completely flush.
Attach Top Panel (#3) to Left Side Panel (#1-A) and Right
Side Panel (#2-A). Make sure the front of the unit faces
downward. Line up screw holes, use 6pcs Screw F (#41)
to tighten.

Step 8:
Step 9: Install Leveling Feet (#6).
Lift the Storage Cabinet upright after this step
Step 10: Install Corner Protection (#17)
1). Attach Corner Protection on the Top, Middle
and Bottom corners of the cabinet, use 24pcs
Screw N (#54) to tighten.
ASSEMBLY INSTRUCTIONS (pg 10 of 13)
UltraHD Storage Cabinet (Model No. 20164)
Install Back Panels (#8, #9 and #10)
1). Attach Bottom Back Panel(#10) onto both
Bottom of Left and Right Side Panels (#1-A2 and #2-
A2) and Bottom Panel (#4).
2) Attach both Middle Back Panel (#9) above
Bottom Back Panel (#10) the same way. Place the
groove of the Middle Back Panel (#9) onto the top
edge of the Bottom Back Panel (#10).
3) Place the Upper Back Panel (#8) the same way.
4) Line up all the screw holes, use 29pcs (#41)
Screw F to tighten the Back Panels.
Install Leveling Feet (#6) into the largest corner
holes of the Bottom Panel (#4), use Wrench (#25)
to tighten.

Step 11: Install Magnet (#23) and Magnet-B (#23-B)
Step 12: Install Door (#6-A)
NOTE:
Step 13:
1). Attach Door (#6-A) to Right Side Panel (#2-A), use
10pcs Screw F (#41) to tighten.
The screw holes on the door hinge have tolerance,
enabling the door to be adjusted and centered in
the door frame. Place top, middle and bottom
screws first. Don't tighten screws completely - this
may save time by avoiding having to make slight
adjustments for leveling door panels later.
Install Middle Shelves (#5)
1). Decide the height for the each Middle Shelf (#5).
Place 1pc of Hook (#34) into the hook slot where
each corner of shelf should be placed. Make sure
the hooks supporting each shelf are at same height.
Note: All Middle Shelves (#5) need a hook at each
corner to support it.
2). Place each Middle Shelf (#5) into cabinet and
push down onto Hooks (#34).
ASSEMBLY INSTRUCTIONS (pg 11 of 13)
UltraHD Storage Cabinet (Model No. 20164)
Place Magnet (#23) onto Top Panel (#3) and Bottom
Panel (#4) facing the front, use 4pcs Screw F (#41) to
tighten.
Place Magnet-B (#23-B) on the front of the Middle
Layer Panel(#7), use 2pcs Screw F (#41) to tighten.

Step 14:
Stainless Steel Maintenance:
These parts have an UltraGuard® fingerprint resistant finish. Do not use
traditional stainless steel cleaners on this unit. Lightly wipe off once a month
with clean warm water and a soft cloth (preferably a microfiber cloth). This is
the safest formula to prevent new stains from appearing over time and
manage unwanted fingerprints or grease marks. Remember to always wipe
in the direction of the surface grain (NEVER ACROSS) and always use a lint-
free cloth. Once the surface is clean,thoroughly wipe dry with a soft
absorbent cloth.
ASSEMBLY INSTRUCTIONS (pg 12 of 13)
UltraHD Storage Cabinet (Model No. 20164)
A. Remove 1 pc Screw F (#41) from the back corner
protection.
Install Mounting Strap (#60)
B. Attach the Mounting Strap (#60) to the back
Corner Protection brackets as the left photo shows
using Screw O (#61) and Washer (#27).
C. Drill a hole in the wall with a 5/16" drill bit, insert
the Wall Anchor (#55-A) into the hole.
D. Attach the other end of the Mounting Strap (#60)
to the wall using Screw M (#55) and Washer (#27-B).
Repeat steps A through D to install the other
mounting strap.
Warning: To prevent possible tipping, it is suggested that the
Mounting Straps be installed. For safety, secure the mounting
straps to wood studs whenever possible.

***Please visit our website or call and inquire about our additional UltraHD Line***
Website & Online Store: www.sevilleclassics.com
CONTACT INFORMATION (pg 13 of 13)
*If you are missing any parts, have any questions, or need additional assistance in assembly, please contact
our bilingual (English and Spanish) customer service department at:
Seville Classics, Inc.
19401 South Harborgate Way
Torrance, CA 90501
USA
Telephone: [phone] within USA
Hours: 9:00am - 4:30pm (Pacific Standard Time)
Fax: [phone]
E-mail: [email protected]
UltraHD Line
Model No. 16238
UltraHD Storage Cabinet
Model No. 16236
UltraHD Storage Cabinet
Model No. 20204
UltraHD 6-Drawer Rolling Cabinet
Model No. 20238
UltraHD Rolling Cabinet

Model No. 20262
UltraHD Rolling Workbench
Model No. 20283
UltraHD Mobile Work Table
Model No. 20217
UltraHD Trash Bin
Model No. 20255
UltraHD Tool Box
UltraHD Line
Model No. 20206
UltraHD Workbench
Model No. 20230
UltraHD Wall Cabinet