Seville Classics FRN04717 User manual

ASSEMBLY INSTRUCTIONS
Magazine Rack (Model # FRN04717)
14.5 in × 13.5 in × 15.5 in
(36.8 cm × 34.3 cm × 39.4 cm)
Patents Pending
Classic Lines Collection (Page 5 of 5)
The full “Classic Lines” furniture collection can be found at
www.sevilleclassics.com
Media Center/Coffee Table (FRN04715)
Wine Rack (FRN04716)
Shoe Rack (FRN04720)
2-Tier Tower (FRN04721)
Assembly Instructions (Page 4 of 5)
CAUTION:
1) Do NOT over tighten the screws. Doing so may
damage the unit.
2) Do NOT place the unit in high temperature area or
near appliances that emit large amount of heat.
3) Do NOT place the unit outdoor, as exposure to direct
sunlight may cause the color to fade.
4) Do NOT place the unit on uneven surfaces. Doing so
may cause the unit to tip over.
5) Examine the screws periodically and tighten them if
they are loose.
6) Weight capacity: 50 lb
If you are missing any parts, have any questions, or need
additional assistance in assembly, please contact our
bilingual (English & Spanish) Customer Service
Department at:
Seville Classics, Inc.
Torrance, CA 90501 USA
Telephone: [phone] toll free within USA
310-533-3800
Fax: [phone]
Monday through Friday 8:30am - 4:30pm
(Pacific Standard Time)
E-mail: [e-mail]
Website & Online Store: www.sevilleclassics.com

Parts List (Page 1 of 5)
Please check the parts you received according to the
parts list below. If you are missingany parts, please
contact our Customer Service Department. (Please refer
to page 4 of 5)
(A) (B)
Folded Magazine Rack (1 pc)
(A) Long Screw (3 pcs)
pre-inserted into the unit
(B) Short Screw (4 pcs)
2 of 4 pre-inserted into the unit
*Tool needed: Phillips Screwdriver
Assembly Instructions (Page 2 of 5)
Step 1: Use a Phillips screwdriver to loosen the 3 Long
Screws (A) that have already been pre-inserted into the
unit. Do NOT remove the screws from the unit. Simply
loosen them to allow the unit to unfold. Next, place the
compressed unit horizontally and position your hands to
carefully unfold the unit.
Please Note:
Do NOT place the unit vertical when unfold as this may
result in the unit suddenly unfolding and pinching your
fingers.
Assembly Instructions (Page 3 of 5)
Step 2: Refer to the picture below. First, tighten the 3
pre-inserted Long Screws (marked “A” in the picture).
Next, screw-in and tighten the 4 Short Screws (B) into the
4 screw holes on the unit (these screw holes are marked
“B” in the picture). Do NOT over tighten the screws.
How to Fold the Magazine Rack (If Needed): First, fully
loosen and remove all 4 Short Screws (marked “B” in the
picture above) from the unit. Next, fully loosen (about 5
turns), but do NOT remove, the 3 remaining pre-inserted
Long Screws (marked “A” in the picture above). Finally,
carefully fold down the unit. Please note that the unit
CANNOT be folded completely flat. Forcing the unit into a
folded position without first removing the 4 Short Screws
and fully loosening the 3 pre-inserted Long Screws may
result in irreparable damage to the unit.