Seville Classics WEB671 User manual

D
E
F
G
I
12 Drawer rolling
Storage cart
Safety
Total unit loading capacity : 56.1 lbs
DO NOT place more than 3.3 lbs. in each small/big drawer. DO NOT attempt
to climb, stand, or lean on cart.
Note: The screws can sometimes loosen over time and may need to be
tightened, keep the Hex Key in one of the drawers for easy access and
tighten the screws on the frames and crossbars.
Clean with mild soap and damp cloth. Remove any excess water with towel.
Model: WEB671
Clip SHELF (D) onto
the &5266%$56 (C)
at the top of the unit.
STEP 4.
Attach DRAWER PULL (I) to
SMALL DRAWER (E) and
LARGE DRAWER (F) with
SCREW (G)XVLQJa
VFUHZGULYHU.
Insert the SMALL DRAWER
(E) and LARGE DRAWER (F)
into the drawer tracks.
Customer Service Information
Telephone: [phone]
Fax: [phone]
Hours (M-F): 8:30 AM – 4:30 PM (PST)
Email: [email protected]
Homepage: www.SevilleClassics.com
Thank you for choosing Seville Classics! We hope that you enjoy your new
cart. Please read through this user guide for parts list, assembly instructions,
and contact information.

A. Side Frame (2)
B. Middle Frame (1)
C. Crossbars (4)
D. Shelf (1)
E. Small drawer (8)
F. Large drawer (4)
G. Screw (12)
H. Hex screw (12)
I. Drawer pull (12)
J. Washer (8)
K. Caster sleeves (4)
L. Casters (2)
M.Locking casters (2)
N. Hex key (1)
H
H
H
H
H
H
H
H
H
H
J
J
J
J
H
J
J
J
J
loading capacity
3.3 lbs (1.5 kgs)
loading capacity
3.3 lbs (1.5 kgs)
K
L
M
K
K
K
L
K
M
Attach the SIDE FRAME (A) to the
4 CROSSBARS (C) with 8 of
WASHERS(J) and HEX SCREWS
(H). Flat side of washer MUST face
end of crossbar. Curved side of
washer MUST fit around frame, as
depicted in below image.
Please using HEX KEY (N) fully
tighten the screws at this stage
Fit CASTER SLEEVES (K) to the
bottom of SIDE FRAME (A).
Make sure they snap all the way
in and are level with each other.
Place CASTERS (L) and
LOCKING CASTERS (M) into the
CASTER SLEEVES (K).
The casters should be pushed in
firmly until they click into place.
Make sure the 2 locking casters
are facing the same direction
next to each other.
NOTE: Screwdriver is required but is not included.
JH
Using 4 of the HEX SCREWS (H),
attach the 4 CROSSBARS (C)
into the MIDDLE FRAME (B).
Ensure that the drawer tracks are
level with each other.