Shanty 2 CHIC Kids Sand Table User manual

Kids Sand Table
Copyright © 2014 Shanty-2-Chic.com
Supply List
Item Quantity Description
1 x 4 x 10’ 3 Pine or whitewood boards
1 x 2 x 6’ 1 Pine or whitewood boards
1 x 2 x 4’ 1 Pine or whitewood boards
2 x 3 x 8 3 Pine or whitewood boards
1-1/4” Pocket Hole Screws 15 Coarse thread for lid slats
2-1/2” wood screws 32 For 2 x 3 frame
Brad nails Handful To attach the lower slats and lid trim
Wood glue
Sand bin

Shanty-2-ChiC.Com KidS Sand table - Page | 2

Shanty-2-ChiC.Com KidS Sand table - Page | 3
Assemble two sides of the frame.
Use glue and two 2-1/2” pocket hole
screws at each joint. The height of the
bottom shelf is up to you but this mod-
el shows the bottom rail 1” off of the
ground.
Connect the two sides with the remain-
ing four rails in the same way. Make
sure the bottom rail is the same height
as before
Add the lower shelf slats. These are
evenly spaced out and just tacked
down with brad nails and glue.

Shanty-2-ChiC.Com KidS Sand table - Page | 4
Assemble the lid slats with 1-1/4”
pocket hole screws.
Attach the short tim pieces to the
ends of the lid slats. Use glue and at
least one brad nail per slat.
Add the final trim pieces to the top
assembly. use glue and brad nails
every six inches or so.