Shanty 2 CHIC Turned Leg Console Table User manual

Turned Leg Console Table
Copyright © 2014 Shanty-2-Chic.com
Supply List
Item Quantity Description
13-1/2” x 30” x 3/4” plywood 1 For the lower shelf
1 x 6 x 6’ 3 Pine or whitewood board
1 x 4 x 6’ 2 Pine or whitewood board
1 x 2 x 6’ 2 Pine or whitewood board
1-1/4” pocket hole screws 104
Brad nails handful Optional for attaching the lower trim
2” x 2” x 30” turned legs 6 A link to the legs we used can be found on our website
Wood glue
Finish of choice

Turned Leg ConsoLe TabLe - Page | 2shanTy-2-ChiC.Com
Drill pocket holes for 1-1/4” pocket hole screws as indicated by the arrows. Use wood glue
at every joint in this project.

Turned Leg ConsoLe TabLe - Page | 3shanTy-2-ChiC.Com
Attach the lower trim pieces
to the lower shelf. Make sure
the top sides are flush.
This table will be built upside down.
Start the assembly with the legs and
the top rails. Make sure the pocket
holes to attach the top panel are facing
the right direction. Attach all of the rails
so that the outside faces is inset 1/4”
from the outside faces of the legs.
Attach the lower shelf with
pocket hole screws through
the plywood panel and the
trim boards.

Turned Leg ConsoLe TabLe - Page | 4shanTy-2-ChiC.Com
Glue and assemble the
planked top.
Carefully place the base
assembly on the top panel
and secure it with pocket hole
screws.
Sand and finish as you wish. Be
sure to personalize your console
to add your own touches. After
your done stop by our website
and let us know! We love seeing
what you can come up with too!