Shark HP200 Series User manual

READ AND SAVE THESE INSTRUCTIONS
Remove Enclosed Filter From
Packaging Before Operating
visit qr.sharkclean.com/hp200series or
SCAN HERE
USING YOUR SMARTPHONE CAMERA
FOR FULL INSTRUCTIONS, TO PURCHASE
ACCESSORIES, OR TO REPLACE FILTERS.
IMPORTANT SAFETY INSTRUCTIONS
HOUSEHOLD USE ONLY
WARNING
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY:
READ ALL THESE INSTRUCTIONS BEFORE USE.
1. This appliance has a polarized plug (one blade is wider
than the other). To reduce the risk of electric shock, this
plug is intended to fit in a polarized outlet only one way.
If the plug does not fit fully in the outlet, reverse the
plug. If it still does not fit, contact a qualified electrician.
Do not attempt to defeat this safety feature. Unplug
or disconnect the appliance from the power supply
before servicing.
2. DO NOT operate any unit with a damaged cord or
plug. Discard the unit or return to an authorized service
facility for examination and/or repair.
3. DO NOT run cord under carpeting. DO NOT cover
cord with throw rugs, runners, or similar coverings.
DO NOT route cord under furniture or appliances.
Keep cord away from high traffic areas where it will
not be tripped over.
4. If the power cord is damaged, it must be replaced by
the manufacturer, its service agent, or similarly qualified
persons in order to avoid a hazard.
5. This appliance is not intended for use by anyone
(including children) with reduced physical, sensory
or mental capabilities, or lack of experience and
knowledge, unless they have been given supervision or
instruction concerning use of the appliance by a person
responsible for their safety.
6. Children should be supervised to ensure that they
DO NOT play with the appliance.
7. Cleaning and user maintenance shall not be made by
children without supervision.
8. Prior to cleaning or other maintenance, the appliance
must be unplugged from the electrical outlet.
9. DO NOT handle plug or appliance with wet hands.
10. DO NOT use without filter in place.
11. Only use Shark® branded filters and accessories.
12. DO NOT damage the power cord:
a) DO NOT pull or carry appliance by the cord or use
the cord as a handle.
b) DO NOT unplug by pulling on cord. Grasp the plug,
not the cord.
c) DO NOT stand the appliance on the power cord,
close a door on the cord, pull the cord around sharp
corners, or leave the cord near heated surfaces.
13. DO NOT use with any opening blocked; keep free of
dust, lint, hair, and anything that may reduce airflow.
14. DO NOT use if airflow is restricted. If the air paths
become blocked, turn the appliance off and unplug from
electrical outlet. Remove all obstructions before you
plug in and turn on the unit again.
15. DO NOT use if appliance is not working as it should, or
has been dropped, damaged, left outdoors, or dropped
into water.
16. DO NOT place appliance on unstable surfaces such as
chairs or tables.
17. DO NOT use in the following areas:
a) Wet or damp surfaces
b) Outdoor areas
c) Spaces that are enclosed and may contain explosive
or toxic fumes or vapors (lighter fluid, gasoline,
kerosene, paint, paint thinners, mothproofing
substances, or flammable dust)
18. Turn off all controls before plugging in or unplugging
the appliance.
19. Unplug from electrical outlet when not in use and
before any maintenance or cleaning.
20. Hand-wash with water only. Washing with cleaning
chemicals could damage the unit.
21. Make sure filter is in place after routine maintenance.
22. Not suitable for use with solid-state speed controls.
REMOTE BATTERY
23. Dispose of batteries properly. Keep batteries away
from children at all times. Even used batteries can
cause injury.
WARNING: Chemical Burn Hazard. Keep batteries away
from children.
This product contains a lithium button/coin cell
battery. If a new or used lithium button/coin cell
battery is swallowed or enters the body, it can cause
severe internal burns and can lead to death in as little
as 2 hours. When not changing batteries, keep the
battery compartment completely closed. If the battery
compartment does not close securely, stop using the
product, remove the batteries, and keep them away
from children. If you think batteries might have been
swallowed or placed inside any part of the body, seek
immediate medical attention.

© 2022 SharkNinja Operating LLC. SHARK is a registered trademark of SharkNinja Operating LLC.
HP200_QSG_E_W3_MP_Mv1
SETTING UP YOUR UNIT
RECOMMENDATIONS
TRY THESE TIPS TO ENSURE
CLEAN AIR CONFIDENCE.
• Run on Auto Mode—it’ll adjust fan
speeds automatically. As air quality
decreases, the fan speed will increase.
After 100% clean air status is achieved
for 10 minutes in Auto Mode, your air
purifier will enter Eco Mode. If particles
are detected, your fan will turn back on.
• Don’t wash filters—they’re designed to
perform optimally for 8–12 months on
their own.
LOWER AIR QUALITY HAPPENS.
Potential causes:
• Cooking • Smoke
• Burning food • Pollen
• Dust • Cleaning products
WANT TO MUTE YOUR AIR
PURIFIER'S BEEPING?
To control your unit's beeping, hold
the Air Info and Child Lock buttons
at the same time for two seconds.
Please be sure to read and save the warnings on other side prior to using your unit.
QUICK START GUIDE
Your Shark® HP200 Series Air Purifier removes allergens, mold,
bacteria, and other particles from your air for a cleaner home.
visit qr.sharkclean.com
/hp200series or
SCAN HERE
USING YOUR SMARTPHONE CAMERA
FOR FULL INSTRUCTIONS,
TO PURCHASE ACCESSORIES,
OR TO REPLACE FILTERS.
1. First, carefully flip the air purifier upside
down and place it on a level surface.
Twist the filter door to unlock the filter.
2. Take the filter out of its packaging,
then insert it back into the unit.
DO NOT run the air purifier unless
the filter is removed from its packaging
and properly reinstalled.
3. With the filter reinstalled, twist the filter
door until it clicks into place.
32
Remove filter
from plastic
packaging
3-inch
minimum
45
4 Set up the unit on a level surface, at
least 3 inches (8-cm) away from walls
and objects.
5. Plug the unit into an electrical outlet
and press the power button on the top
control panel. When the unit is powered
on, it will begin to analyze the air quality
indicated by the rotating lights. After
a few seconds the unit will display the
current air quality.
HP200
1