Listening to a cassette tape
CD-SW200
TAPE 1 TAPE 2
Listening to the radio
CD-SW200
Listening to a CD or MP3/WMA disc
1Press the CD button.
2Press the 1 button and within 5 seconds, press the OPEN/CLOSE
button to open the disc tray 1.
3Place the disc on the disc tray 1, label side up.
4Press the OPEN/CLOSE button to close the disc tray 1.
5You can place discs on trays 2 - 5 by following steps 2 - 4.
6Press the / button to start playback.
12 cm (5”) 8 cm (3”)
1Press the TUNER (BAND) button repeatedly to select the desired
frequency band (FM or AM).
2Press the TUNING ( or ) button to tune in to the desired sta-
tion.
When the TUNING button is pressed for more than 0.5 seconds, scan-
ning will start automatically and the tuner will stop at the first re-
ceivable broadcast station.
To receive an FM stereo transmission:
Press the TUNER (BAND) button to display the “ST”indicator.
“ ” will appear when an FM broadcast is in stereo.
1Open the cassette compartment
by pushing the area marked “”.
2Load a cassette into the TAPE 1 compartment or
TAPE 2 compartment with the side to be played
facing towards you.
3Press the TAPE (1 2) button to select the cassette you want to
listen to.
4Press the / (TAPE ) button to start playback.
FM stereo mode indicator
FM stereo receiving indicator
CD-SW200
If trouble occurs
When this product is subjected to strong external interference
(mechanical shock, excessive static electricity, abnormal supply
voltage due to lightning, etc.) or if it is operated incorrectly, it may
malfunction.
If such a problem occurs, do the following:
1. Set the unit to the stand-by mode and turn the power on again.
2. If the unit is not restored in the previous operation, unplug and
plug in the unit, and then turn the power on.
Note:
If neither operation above restores the unit, clear all the memory by
resetting it.
Clearing all the memory (reset)
1. Press the ON/STAND-BY button to enter the power stand-by
mode.
2. Whilst pressing down the button and the X-BASS
(SURROUND)/DEMO button, press the TUNING button until
"CLEAR ALL" appears.
Caution:
This operation will erase all data stored in memory including clock,
timer settings, tuner preset, and CD programme.
Maintenance
Routine maintenance is required for continued optimum perfor-
mance, refer to the operation manual.
CD-SW200E QG 10/3/05, 4:03 PM2
Downloaded from: http://www.usersmanualguide.com/
