Silver Cross POP User manual

Pop
IMPORTANT: KEEP THESE INSTRUCTIONS
FOR FUTURE REFERENCE

2
These instructions are important.
Read these instructions carefully before use
and keep them for future reference. Your
child’s safety may be affected if you do not
follow these instructions. Your Pop pushchair
is a high quality Silver Cross product. It
meets current safety standards and care and
regular light maintenance will ensure long
service. This vehicle is intended for children
from birth to 25kg. If somebody unfamiliar
is using your Pop pushchair always ensure
that they read these instructions carefully so
that they understand how the product works
best. Always read all the instructions provided
carefully and remember, the safety of your
child is your responsibility.
WARNING: Never leave your
child unattended.
Contents
Your Pop pushchair includes the following
components, please check that you have all
the items before proceeding:
1.1 Pop Pushchair Chassis, Seat Fabrics
and Basket
1.2 Pop Hood
1.3 Pop Raincover
1.4 Pop Front Wheel Assembly x2
1.1
1.2 1.3
1.4

3
silvercrossbaby.com
Assembling the Pop
2.1 Attach the swivel wheels by locating the
wheel under the steel attachment pin.
Slide the wheel upwards and press until
the wheel clicks into position.
WARNING: Check the wheel
is secure by pulling gently
downwards.
Repeat on both sides. Your Pop is now
ready to be unfolded.
2.2 Locate the locking catch on the side of
the pushchair and lift to release from the
locking stud.
2.3 Allow the pushchair to open by lifting
the handles upwards and the wheels will
naturally fall to the floor.
2.1
2.3
2.2

4
Assembling the Pop (continued)
2.4 Finally, press down gently upon the rear
locking catch, positioned between the
rear wheels, to lock your pushchair.
WARNING: Failure to do this
will cause damage to your
pushchair.
Place the pushchair on a flat surface and
ensure that the pushchair moves freely.
2.5 To fit your Pop hood locate the clips
on the hood. Now attach the hood to
the Pop chassis by sliding clips over the
hood connection bracket. A positive
engagement should be ensured.
2.6 Your Pop hood can be opened and
folded by pulling the hood forward
or pushing backwards on the hood
frame. Your hood can also be extended
forwards by unzipping zip as shown in
diagram 2.6. Please note when folding
your Pop pushchair you should always
ensure the hood is folded away. Failure
to do this could result in damage to your
Pop pushchair.
2.4
2.5
2.6

5
silvercrossbaby.com
Assembling the Pop (continued)
2.7 Your Pop pushchair is now ready for use.
2.8 Your Pop pushchair has a multi-position
calf support. Locate the adjustment
levers either side of the calf support.
Pull levers towards you and adjust to the
required position.
2.7
2.8

6
Reclining the Pop
3.1 Your Pop pushchair has a multi- position
recline.
3.2 First, locate the backrest adjustment
mechanism at the rear of the seat. Pull
up the recline lever and gently lower to
the desired position.
3.3 To raise the backrest locate the recline
lever and pull up gently into the desired
position. The backrest will rise to the
desired height.
NOTE: The backrest should always be in
the upright position and the hood folded
away prior to folding.
3.1
3.2
3.3

7
silvercrossbaby.com
BB
A
A
A A
Using the harness
WARNING: Always use the crotch
strap in combination with the
waist belt.
4.1 Start by connecting shoulder clips to
waistclips.
4.2 To fasten the harness insert the pairs of
clips into each side of the buckle. Listen
for the ‘click’.
WARNING: Always use the
restraint system.
To release the harness press the centre
and pull apart. The shoulder clips can be
detached from the waist clips if required.
4.3 Your harness is fully adjustable by
moving the sliders (A), to make fitting
easy.
‘D’ rings are provided for fitting a
separate harness if required (B),
complying with BS 6684. Your child
should always be harnessed in and
should never be left unattended, even
for short periods of time.
4.1
4.2
4.3

8
Using the brakes
5.1 Your Pop pushchair has a parking
brake. To apply the brake simply press
downwards on either brake catch
located on the rear wheels. The brake
will automatically lock on both wheels
simultaneously.
WARNING: Please ensure
both brake levers are locked
in position securely.
5.2 To release the parking brake simply lift
either brake catch and both catches will
release simultaneously.
NOTE: Always apply brake when placing
and removing your child.
5.1
5.2

9
silvercrossbaby.com
Using the wheel locks
6.1 Your Pop pushchair has front swivel
wheels. To lock your swivel wheels locate
the catch between the front wheels.
Press down in any position. The wheels
will automatically lock when the wheels
are rotated. Repeat on each front
wheels. To use the wheels in swivel
mode lift the locking catch and the
wheels will swivel freely. Repeat on each
wheel.
6.1

10
Folding the Pop
NOTE: The backrest should always be in
the upright position and the hood folded
away prior to folding.
7.1 To start folding, locate the rear locking
catch (positioned between the rear
wheels) and lift upwards with the toe of
your shoe.
7.2 Now locate the secondary safety catch
located above the right hand rear wheel.
Gently press down until the lock has
released.
7.1
7.2