
10 GB/CY
possible to activate the product. You can always
press the button TARE 3at any time to set the
zero point.
Place the item you wish to weigh onto the product.
The numerical display 7will show the weight of
the item you are weighing.
Incremental weighing
Touching the button TARE 3with the product on
will change the numerical display 7from the
reading to “0“. The “T“ symbol 10 will appear.
Note: A slight touch of the button TARE
3
and the
button UNIT 4is sufficient to operate the product.
If there is too much pressure, the product may
cause tilting.
Now add another item to weigh onto the product.
The numerical display 7will show the weight of
the newly added item.
If you remove the item added to the product, the
numerical display 7will again read “0“.
If you remove all items from the product, the LC
display 2will show a negative value indicated
by the minus symbol 9.
Then briefly touch the button TARE 3, and the “T“
symbol 10 will disappear.
Important! Be sure never to add more than 5kg
to the weighing surface
1
. Overloading the product
can damage it.
Changing the measuring unit
The product will display the weight in the official Euro-
pean measuring unit “g“ (grams), as well as the tradi-
tional unit of weight “oz“ (ounce, 1oz ≈ 28.35 g) or
“lb’oz“ (pound: ounce, 1lb = 16oz ≈ 453.59g).
When measuring the volume of water, the product
calculates it by the weight using the official European
unit of volume “ml“ (millilitres) or the traditional unit of
measure fl’oz (fluid ounces, 1fl’oz ≈ 28.41ml).
To switch the unit of measure, briefly touch the UNIT
button 4. After each time it is touched, the unit
display 8will switch to the next unit listed:
g → oz → lb’oz → ml → fl’oz
Switching off
Holding the button TARE 3for approx. 3 seconds
will off the product. If no movement is detected on
the weighing surface 1for 3 minute and no but-
ton is pressed, the product will automatically
switch off.
Troubleshooting
= Fault
= Cause
= Solution
=
= The product is overloaded.
= Remove the overload.
=
= The batteries are too weak to weigh. You cannot
operate the product.
= Replace the battery (see section “Replacing the
battery”).
Note: The product contains sensitive electronic compo-
nents. For this reason it is possible that it can be disr
upted
by radio transmitting equipment in the immediate vicinity.
If the LC display 2indicates a problem, move such
objects away from it.